Reliance Water Heaters 184735-000 instruction manual Leakage Checkpoints

Page 17

LEAKAGE CHECKPOINTS

Read this manual first. Then before checking the water heater make sure the electrical power supply has been turned “OFF” before checking the tank for leakage.

*A. Condensation and dripping may be seen on pipes if the water temperature is low in humid weather or pipe connections may be

 

leaking.

 

B. Small amounts of water from temperature-pressure relief valve

 

may be due to thermal expansion or high water pressure in your

 

area. If the valve is not piped to an open drain the released water

 

could be mistaken for a leaking heater.

 

*C. The temperature-pressure relief valve may be leaking at the tank

 

fitting.

 

E. The element may be leaking at the tank fitting. Turn electrical power

 

“OFF”, remove outer door, insulation block and pad. If leaking

 

around the element, follow proper draining instructions and remove

 

element. Reposition or replace gasket on element. Place element

 

into opening and tighten securely. Then follow “Filling the Water

 

Heater” instructions in the “Installing the New Water Heater”

 

section.

FIGURE 24.

E. Water from a drain valve may be due to the valve being slightly

 

opened.

 

*F. The drain valve may be leaking at the tank fitting.

 

*G. Water in the water heater bottom or on the floor may be from

 

condensation, loose connections, or the relief valve. DO NOT

 

replace the water heater until a full inspection of all possible

 

water sources is made and necessary corrective steps taken.

 

Leakage from other appliances, water lines, or ground seepage

 

should also be checked.

 

* To check where threaded portion enters tank, insert cotton swab

 

between jacket opening and fitting. If cotton is wet, follow

 

“Draining” instructions in the “Periodic Maintenance” section and

 

then remove fitting. Put pipe dope or teflon tape on the threads

 

and replace. Then follow “Filling the Water Heater” instructions in

 

the “Installing the New Water Heater” section.

17

Image 17
Contents Residential Point of USE Electric Important Definitions Safe INSTALLATION, USE and ServiceGeneral Safety Introduction Table of ContentsMixing Valve Usage Typical InstallationLocating the NEW Water Heater Installing the NEW Water HeaterFacts to Consider about the Location Insulation BlanketsWater Piping TEMPERATURE-PRESSURE Relief Valve Filling the Water Heater Optional Cord SET Wiring 120 Volt and 240 Volt Wiring DiagramsWiring Temperature Adjustment Temperature RegulationOperational Conditions For Your InformationTEMPERATURE-PRESSURE Relief Valve Operation Periodic MaintenanceThermostat Removal / Replacement DrainingElement Cleaning / Replacement Service Drain Valve Washer ReplacementLeakage Checkpoints Problem Cause Solution Troubleshooting GuidelinesDrain PAN Repair Parts ListPoint of USE Electric Models

184735-000 specifications

Reliance Water Heaters has established itself as a trusted name in the water heating industry, and the model 184735-000 is a testament to their commitment to delivering quality and efficiency. This water heater is designed to meet the needs of both residential and commercial users, providing reliable hot water supply for various applications.

One of the standout features of the Reliance 184735-000 is its significant storage capacity. With a tank that typically accommodates around 40 gallons, this model is ideal for households with moderate to high hot water usage. This capacity ensures that there is always enough hot water available for daily activities such as showering, washing dishes, and laundry.

The design of the Reliance 184735-000 incorporates advanced insulation technology, which minimizes heat loss. This feature enhances energy efficiency, allowing users to save on energy bills while ensuring optimal performance. The high-density foam insulation wrapped around the tank effectively reduces standby heat loss, making it an environmentally friendly choice.

Another notable characteristic of the 184735-000 is its user-friendly thermostat control. The intuitive dial allows users to easily adjust the water temperature according to preference and needs. This level of customization ensures comfort in hot water usage, whether for a relaxing bath or quick dishwashing.

The unit is also equipped with safety features such as a temperature and pressure relief valve. This mechanism releases excess pressure to prevent potential hazards, making it a reliable choice for peace of mind.

Reliance Water Heaters incorporates high-quality materials in the construction of the 184735-000. The tank is typically made of durable stainless steel or glass-lined steel, offering resistance against corrosion and extending the lifespan of the heater. Additionally, the heating elements are designed for efficient performance, ensuring rapid heating of water when required.

Installation of the Reliance 184735-000 is straightforward, with compatibility for various plumbing configurations. This versatility makes it a preferred option among homeowners and contractors alike.

In summary, the Reliance Water Heaters model 184735-000 combines efficiency, safety, and convenience. With its substantial storage capacity, energy-efficient design, and high-quality construction, it stands out as an excellent choice for anyone in need of a dependable water heating solution. Its user-friendly features further enhance its appeal, making it a noteworthy investment for reliable hot water availability.