Seagate ST39140N/W/WC/LW/LC, ST36530N/W/WC, ST34520N/W/WC/LW/LC General information, Drive models

Page 24

22	Medalist Pro Installation Guide, Rev. B

Initial setup information

The general information beginning on this page applies to all of the Medalist Pro drive models. After reading the general informa- tion topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models			Page
ST39140N	ST36530N	ST34520N	42
ST39140W/LW	ST36530W	ST34520W/LW	46
ST39140WC/LC	ST36530WC	ST34520WC/LC	52

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables1

•Formatting the drive

1This mounting procedure does not apply to “WC” or “LC” model drives. To mount “WC” or “LC” drives, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.

Image 24

Contents ST39140N/W/WC/LW/LC Contents Handling precautions PrefaceElectrostatic discharge protection Important safety information and precautions Medalist Pro Installation Guide, Rev. B Wichtige Sicherheitshinweise Medalist Pro Installation Guide, Rev. B Page Regulatory agency compliance Electromagnetic susceptibilityElectromagnetic compliance Electromagnetic compliance for the European Union Australian C-TickSeagate Technology support services Presales Support Customer Service CSO European Support Services Africa/Middle East Support Services SeaFAX General description Drive characteristics RPMDCX DC power requirements Amps for LW/LC Models ST39140 ST34520Medalist Pro Installation Guide, Rev. B Dimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Terminator power Circuits and data path widthsInterconnect characteristics for single-ended I/O circuits Interconnect characteristics for LVD I/O circuits Fifty pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Medalist Pro Installation Guide, Rev. B Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelMedalist Pro Installation Guide, Rev. B DC power connector Abbildung 5. Gleichstromanschluß Hinweis Page Mounting configuration dimensions Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers Setting the Scsi ID on model N drivesTerminating the drive Terminating the driveSetting terminator power jumpers Other applicable jumper options Additional jumper optionsLW drives Host Alternate Enable Scsi terminator Disable Scsi terminator Model only Terminator power Additional jumper options for W/LW drives Additional jumper option for LW drives WC/LC drives Applicable jumper options Jumper optionsLC drives Additional jumper options for LC drives Page