Using The Remote Control

The Remote Control controls basic functions on the iP99 and certain iPhone/iPod functions when the iPhone/iPod is docked in the iP99. For best results, use the remote control within 12 feet of the unit.

TLU\		LU[LY
T\[L		YHKPV
		SPULPU
LX	ZSLLW	WYLZL[Z
ZUVVaL

Power On/Off Alarm Reset Button: Turns iP99 ON or OFF or resets alarm when alarm is sounding

Fwd/Rev Button: Skip to previous or next track, or HOLD to scan current playing track. Also controls set wheel functions (changing settings, tuning radio, etc.)

Menu Button: Press to access iPhone/iPod Menu functions

Preset Button: Cycles through AM or FM radio presets

Radio Button: Selects Radio (AM and FM radio bands) and line-in functions

EQ Button: Set Treble, Bass, SRS WOW sound effect and Balance settings for best sound

Snooze/Dimmer Button: Snooze mode when alarm sounds, otherwise dims display

Random Button: Press for random play

Repeat Button: Press for repeat play (press again to repeat all)

Sleep Button: Press to select an amount of time before the iP99 shuts off: 120, 90, 60, 30 or 15 minutes

Volume – Button: Lowers volume level

Volume + Button: Raises volume level

Enter Button: Press to select iPhone/iPod menu function

Up/Down Button: Press Up or Down to scroll iPhone/iPod menu

Play/Pause Button: Plays track. In play mode, press to pause

Mute Button: Toggles sound ON or OFF

Installing/Replacing the Remote Control Battery

The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced,

it is time to replace the battery with a new one.

1.	The battery door is located on the back end of the remote.
2.	Slide the battery door open and remove old battery.
3.	Insert a CR2025 battery, checking that the + and – sides of the battery
	match the drawing inside the battery compartment.	Install
4.	Replace the battery door.	Install
		Remote Control Battery

Note: Make sure you dispose of all batteries properly (see your local regulations).