CONTROLS
7.ACTUATOR SWITCH
Adjusts the amount of brush pressure to the floor by raising or lowering the scrub deck.
To increase brush pressure, press the bottom of the switch.
To decrease brush pressure or rise the scrub deck, press the top of the switch.
8.SOLUTION CONTROL KNOB
Controls solution flow to scrub deck. To increase flow, rotate knob clockwise.
To decrease flow, rotate knob counterclockwise.
If the brush motors are turned off or the propel control levers are in neutral, the flow is automatically interrupted until the motors are turned on again. This feature prevents unintentional draining of the solution tank and allows the operator to adjust the solution flow to the scrub deck without resetting each time the scrubbing operation is interrupted.
9.VACUUM SWITCH
Controls the vacuum motor.
To start vacuum motor, press the bottom of the switch.
To stop vacuum motor, press the top of the switch.
10.SQUEEGEE LIFT LEVER
Raises and lowers the squeegee.
To lower the squeegee, lift the lever from its raised position.
To raise the squeegee, lift the lever from its lowered position.
11.SQUEEGEE PITCH ADJUSTMENT KNOB
Adjusts the deflection at the ends of the squeegee.
To increase squeegee blade deflection at the ends, turn knob counterclockwise.
To decrease squeegee blade deflection at the ends, turn knob clockwise.
12.SQUEEGEE DEFLECTION ADJUSTMENT KNOBS
Adjusts the deflection along the entire length of the squeegee.
To increase squeegee blade deflection along the entire length, turn the two knobs at the squeegee ends
To decrease squeegee blade deflection along the entire length, turn the two knobs at the squeegee ends clockwise.
CUTTER 24V 86039080 04/17/07 |