Wayne-Dalton DS-75, DS-50, DS-100 installation instructions Roll-Up Sheet Door

Page 12

Roll-Up Sheet Door

LIMITED WARRANTY

Wayne-Dalton

P.O. Box 67- Mt. Hope, Ohio 44660

The Manufacturer warrants the ROLL-UP SHEET DOOR and hardware fittings for a period of ONE YEAR from the time of delivery against any defects in workmanship or material. Manufacturer shall, upon notification, correct such nonconformity at its option, by repairing or replacing any defective part or parts.

NO EMPLOYEE, DISTRIBUTOR, OR REPRESENTATIVE IS AUTHORIZED TO CHANGE THE FOREGOING WARRANTIES IN ANY WAY OR GRANT ANY OTHER WARRANTY ON BEHALF OF MANUFACTURER.

The Manufacturer shall not be responsible for any damage resulting to or caused by its products by reason of installation, improper storage, unauthorized service, alteration of products, neglect or abuse, or attempt to use the products for other than the customary usage or for their intended purposes. The ROLL-UP SHEET DOOR warranty becomes null and void if other than Manufacturer’s specified holes are drilled. The above warranty does not cover wear or any damage beyond Manufacturer’s control or replacement labor.

THIS WARRANTY COVERS A COMMERCIAL PRODUCT, THE FOREGOING WARRANTIES ARE IN LIEU OF ALL OTHER WARRANTIES AND NO REPRESENTATIONS, GUARANTEES, OR WARRANTIES, EXPRESSED OR IMPLIED, (INCLUDING, BUT NOT LIMITED TO, THE WARRANTY OF MERCHANTABILITY OR FITNESS FOR PARTICULAR PURPOSE), ARE MADE BY MANUFACTURER IN CONNECTION WITH MANUFACTURE OR SALE OF ITS PRODUCTS.

Claims for defects in material and workmanship covered by this warranty shall be made in writing to the dealer from whom the product was purchased within the warranty period. Manufacturer may either send a service representative or have the product returned to the Manufacturer at Buyer’s expense for inspection. If judged by Manufacturer to be defective in material or workmanship, the product will be replaced or repaired at the option of Manufacturer, free from all charges except authorized transportation and replacement labor.

THE REMEDIES OF BUYER SET FORTH HEREIN ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER REMEDIES. THE LIABILITY OF MANUFACTURER, WHETHER IN CONTRACT, TORT, UNDER ANY WARRANTY, OR OTHERWISE, SHALL NOT EXTEND BEYOND ITS OBLIGATION TO REPAIR OR REPLACE, AT ITS OPTION, ANY PRODUCT OR PART FOUND BY MANUFACTURER TO BE DEFECTIVE IN MATERIAL OR WORKMANSHIP. MANUFACTURER SHALL NOT BE LIABLE FOR COST OF REMOVAL OR INSTALLATION OR SHALL NOT BE RESPONSIBLE FOR ANY DIRECT, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

This warranty gives you specific legal rights which may vary from state to state. However, some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.

Wayne-Dalton

Door & Systems Division

2589 County Road 168

Dundee, OH 44624

1-800-795-5095

12

Image 12
Contents Important Notice Hint Introduction PreparationMaterial ClearancesUnpacking Doors Checking the Door OpeningOpening Height Headroom a Side Room B UP to 6’8 High From 6’8-1/4 to 8’ HighInstalling Guides Installing BracketsLifting the Curtain Assembly Attaching SpringLubricating and Adjusting the Guides PRE-TENSIONING the Door SpringChecking and Adjusting Spring Balance DS-75 Mini ‘Z’ Stop-Clip AttachmentInstalling Optional TOP Draft Stop II DS-50 & 100 ‘C’ Stop-Clip AttachmentIII ‘C’ Stop-Clip w/ Inside Slide Bolt Attachment Page To Increase Spring Tension To Decrease Spring TensionRoll-Up Sheet Door Party Receiving Warranty Basic CoverageLimitations and Exceptions Remedy Limitations on Remedies and LiabilityExclusive Warranty on Paint Other TermsNo Modification of Terms