Wayne-Dalton DS-100, DS-75, DS-50 installation instructions Hint

Page 2

IMPORTANT SAFETY NOTICES

Read the enclosed instructions carefully before attempting installation. If there are any questions about any of the procedures, do not perform the work. Instead, have a trained door technician do the installation or repairs.

1.Operate the door ONLY when it is properly adjusted and free of all obstructions.

2.The door is constantly under EXTREME SPRING TENSION. Repairs, adjustments, installation and removal, ESPECIALLY of SPRINGS AND RELATED PARTS, are dangerous. Such work should be performed ONLY by trained door technicians.

3.DO NOT PERMIT children to play with the door. Children could get caught between the door and the floor causing severe injury or death.

4.Avoid standing in the open doorway or walking through the doorway while the door is moving. One could get caught between the door and the floor causing severe injury or death.

5.Should the door become hard to operate or completely inoperative, it is recommended that a trained door technician correct the problem to prevent possible injuries or door damage.

6.Avoid installing the door on windy days. The door could fall causing personal injury or door damage.

7.To prevent injuries due to loose components, at least monthly check all bolted connections to make sure they are secure.

8.To prevent injuries, never place hands or fingers between the curtain and the guides while the door is being operated.

9.This manual is not intended to provide "take-down" instructions for existing doors. Consult your local door agency if this is required, before new doors are to be installed.

10.Thoroughly familiarize yourself with the building codes in your region before initiating work.

11.Wear the proper protective safety gear at all times when installing, adjusting, and/or repairing doors.

12.Use a 2-person (or larger) crew for installing, adjusting, and/or repairing larger doors.

13.Definitions of key words used in this manual are as follows:

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.

WARNING

CAUTION

CAUTION

IMPORTANT!

WARNING indicates a potential hazardous situation which, if not avoided, could result in serious injury or death.

CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

CAUTION used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage.

IMPORTANT! indicates a required step for safe and proper door operation.

NOTE:

HINT:

NOTE: indicates information assuring proper installation of the door.

HINT: indicates a suggested step to simplify installation based on experience.

2

Image 2
Contents Important Notice Hint Material IntroductionPreparation ClearancesOpening Height Headroom a Side Room B UP to 6’8 High Unpacking DoorsChecking the Door Opening From 6’8-1/4 to 8’ HighInstalling Guides Installing BracketsLifting the Curtain Assembly Attaching SpringLubricating and Adjusting the Guides PRE-TENSIONING the Door SpringChecking and Adjusting Spring Balance DS-75 Mini ‘Z’ Stop-Clip AttachmentIII ‘C’ Stop-Clip w/ Inside Slide Bolt Attachment Installing Optional TOP Draft StopII DS-50 & 100 ‘C’ Stop-Clip Attachment Page To Increase Spring Tension To Decrease Spring TensionRoll-Up Sheet Door Limitations and Exceptions Party Receiving WarrantyBasic Coverage Remedy Limitations on Remedies and LiabilityNo Modification of Terms Exclusive Warranty on PaintOther Terms