Wayne-Dalton 346919 installation instructions Bolts and nuts, To 7/8

Page 14

Sound framing members

(3) 5/16”

Bolts and nuts

Horizontal track

Perforated angle

5/16”-18 x 1-1/4” Hex bolts must extend into the track to serve as a roller stop

Perforated angle bolted using (2) 5/16” x 1-5/8” hex head lag screws to ceiling member and parallel to door

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,

refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Image 14

Contents 6100 B l e O f C o n t e n t sParts Breakdown Important Safety Instructions Tools Required Lock Section can be identified by #2 graduated end hinges Attempt is made to start removing an existing doorDoor, complete all steps in preparing the opening Found not to be sound, must be replacedLHR 229 mm BackroomHeadroom Requirements Page Pull Handles Bottom Corner BracketsStacking Sections Bottom SectionVertical Tracks Top Section Top FixturesStrut A-symmetrical Drawbar Operator BracketHorizontal Tracks/F.A. Flag Angles Adjusting Top FixturesHorizontal Tracks/Q.I Flag Angles End Bearing BracketsTorsion Spring Attachment Center Bracket Bushing AssemblyTorsion Spring Assembly Winding Springs Tools Vice ClampsRear Back Hangs Bolts and nuts To 7/8Pull Down Rope Door Arm HookupInside Lock Following cleaning solution is recommended Touch up where necessaryWood Maintenance and Refinishing Use in general cleaning of garage doorsPage Warranty Lifetime Limited Warranty Model