Door Arm Hookup, Inside Lock, Pull Down Rope

Optional Installation

Door Arm Hookup

Tools: Needle nose pliers

Align hole in the door arm with holes in drawbar operator bracket tabs, as shown. Insert 5/16” x 1-1/4” clevis pin, making sure hole in clevis pin is outside of second tab of drawbar operator bracket. Insert hairpin cotter into clevis pin hole and spread hairpin cotter to secure assembly, as shown.

	Door arm
5/16”x 1-1/4”	Cotter	Clevis pin
5/16”x 1-1/4”	pin
Clevis pin
	Drawbar operator
Drawbar	bracket tabs	Spread cotter pin
operator bracket

Inside Lock

Tools: Power drill, 7/16” Socket driver, Tape measure

Install the inside lock on the second section of the door. Secure the lock to the section with (4) 1/4”-20 x 11/16” self drilling screws. Square the lock assembly with the door section, and align with the square hole in the vertical track. The inside lock should be spaced approximately 1/8” away from the section edge.

Important: Inside lock(s) must be removed or made inoperative in the unlocked position if an operator is installed on this door.

Second section	1/8”
Inside lock

End cap

Square hole in vertical track

(4)1/4”-20 x 11/16” Self drilling screws

Pull Down Rope

Tools: Power drill, 1/8” Drill bit, Tape measure

WARNING

Do not install pull down rope on doors with operators. Children may become entangled in the rope causing severe or fatal injury.

Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the no. 6 screw eye and to the bottom corner bracket, as shown.

No. 6 Screw eye

Pull down rope

48” to 50” From ﬂoor

Pull down rope

Bottom corner bracket

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,

refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com