Desa SL-5326 manual Test and Adjustment, Specifications, Bottom of Sensor, Maximum Range

Clamp Screw

Ball

Joint

Aim Sensor

Down for Short

Coverage

Aim Sensor

Higher for Long

Coverage

TEST AND ADJUSTMENT

❒Turn on the circuit breaker and light switch.

NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When fi rst turned on, wait 1 1/2 minutes.

❒Turn the RANGE control to the mid position, 2-Level Lighting to OFF and the ON-TIME control to the TEST position.

MAX
B	O	ON - TIME	DUAL BRITE
	O
	T	S
MIN
		TEST 1 5 2 0	OFF 3 6	DUSK TO
RANGE
		MINUTES	HOUR	DAWN

Bottom of Sensor

Avoid aiming the control at:

•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects refl ecting light may trigger the shut-off feature. Do not point other

lights at the sensor.

❒ Loosen the clamp screw in the sensor ball joint and gently rotate the sensor.

❒ Walk through the coverage area noting where you are when the lights turn on (also, the LED will fl ash several times when motion is detected).Move the sensor head up, down, or sideways to change the cover- age area. Keep the sensor at least 1" (2.5 cm) away from the lamps.

❒Adjust the RANGE as needed.

RANGE set too high may increase false triggering.

❒ Secure the sensor head by tightening the clamp screw. Do not overtighten the screw.

❒Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 20 minutes).

❒Set the 2-LEVELLighting switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs., Dusk-to-Dawn).

Warning - Risk of fire. Do not aim the lamps at a combustible surface within 3 ft. (1 m).

240°

8 ft.

(2.4 m)

70 ft. 100 ft.

(21 m) (30.5 m) Boosted

Maximum Range	Maximum
	Coverage Angle

The detector is most sensitive to motion across its fi eld of view.

MotionMotion

	Sensor
Least Sensitive	Most Sensitive

SPECIFICATIONS

Range	Up to 70 ft. (21 m); 100 ft.
	(30.5 m) with Range Boost.
	[varies with surrounding tem-
	perature]
Sensing Angle	Up to 240°
Electrical Load	Up to 300 Watt Maximum
	Incandescent [Up to 150
	Watt maximum each lamp
	holder.]
Power Requirements	120 VAC, 60 Hz
Operating Modes	TEST, AUTO and MANUAL
	MODE
Time Delay	1, 5, 20 minutes
2-Level Lighting Timer ....	3, 6 hours, Dusk-to-Dawn

DESA Specialty Products reserves the right to discon- tinue products and to change specifi cations at any time without incurring any obligation to incorporate new features in products previously sold.

598-1274-00 3