Baracoda RS232RS232 manual Only for BCC2604/BL2604/BLR2604 productts

Page 17

Data Capture

for Workforce

in Motion

Only for BCC2604/BL2604/BLR2604 productts

The Number of Beeps for ‘good scan’

Warning: These settings are only possible with BC/BL-2604 scanners. After scanning the desired barcode, disconnect the scanner (reading the “Disconnect barcode”), wait for ten seconds and connect again using the “Connect barcode.”

0 beep [default]

1 beep

2 beeps

3 beeps

DISCONNECT

Baracoda RS232 dongle Plug & Scan – User Guide v3.28.2

- 17 -

Image 17

Contents RS 232 dongle Plug & Scaan User Guide Summary Revision History Introduction Hardware description Technical IntroductionScanneer Status dongle link Batch mode No data loss modeEnable batch mode How to use with RoadRunnersData Capture For Workforce Motion How to connect your BC2604/BL2604/BLR2604 How to connect your Baracoda barcode scannerHow to connect your BaracodaPencil/Pencil2 How to connect your D-Fly How to connect your BCM2604-L/BCM2604-FHow to connect your ToughRunners How to connect your RoadRunners/RoadRunners EvolutionHow to connect your ScanWear How to connect your DualRunners Disconnect barcode How to disconnect your Plug & Scan DongleSuffix Additional featuresPrefix Uart Settings Only for BCC2604/BL2604/BLR2604 productts Number of Beeps for ‘A CK’in ‘no data loss mode’ Print firmware version Transparent modeCompatibility Limited Warranty