Kidde KN-COPP-3-RC manual What Carbon Monoxide Alarms Can and Cannot Do

Page 10

Features

What Carbon Monoxide Alarms Can and Cannot Do

CO alarms are designed to sense unacceptable levels of CO from malfunctioning furnaces, appliances, gas engines or other sources.

This Carbon Monoxide alarm is not a substitute for installing and maintaining an operational smoke alarm.

CO alarms provide early warning of the presence of carbon monox- ide, usually before a healthy adult would experience symptoms. This early warning is possible, however, only if your Carrier CO alarm is located, installed and maintained as described in this user’s guide.

This CO alarm is designed to act as a monitor, it is not designed for use as a short-term testing device to perform a quick check for the presence of CO.

CO alarms have limitations. Like any other electronic device, CO alarms are not fool-proof.

CO alarms have a limited operational life. You must test your CO alarm weekly, because it could fail to operate at any time. If your CO alarm fails to test properly, or if its self-diagnostic test reveals a malfunction, immediately have the unit replaced. See back page for warranty information. This CO alarm also has an "operational end of life" feature which will indicate when to replace the alarm. See page 25 for details of this feature.

CO alarms can only sense CO that reaches the unit’s sensor. Carbon monoxide may be present in other areas without reaching the alarm. The rate at which CO reaches the unit may be affected by doors or other obstructions. In addition, fresh air from a vent or open window or any other source may prevent CO from reaching the sensor. Please observe cautions on page 8 “Where to install your alarm.”

CO could be present on one level of the home and not reach a CO alarm installed on a different level. For example, CO in the base- ment may not reach an alarm on the second level, near the bed- rooms. For this reason, we recommend you provide complete cov- erage by placing a CO alarm on every level of the home.

CO alarms are not smoke alarms. CO alarms do not sense smoke or fire. For early warning of fire you must install smoke alarms, even though carbon monoxide can be generated by a fire.

CO alarms should not be used to detect the presence of natural gas (methane), propane, butane, or other combustible fuels.

CO alarms are not a substitute for property, disability, life or other insurance of any kind. Appropriate insurance coverage is your responsibility. Consult your insurance agent.

7

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Carbon Monoxide Table of Contents Page Quick Set Up Guide Setting up your alarm for first time operationQuick Set Up Guide Introduction Features Carrier CO Alarm front viewDigital Display Rear view with back door removed Pull-Out Transformer/AdapterWhat Carbon Monoxide Alarms Can and Cannot Do Where to Install Your CO Alarm InstallationRecommended Locations Where Not to Install Your CO Alarm AT Least 5 feet away from applianceTo install How to Install Your AlarmDirect Plug Alarm Avoid the followingIf the outlet is mounted horizontally sideways Wall Mounted AlarmPlug the alarm into an unswitched wall socket To rotate the adapterOr drywall, drill a 3/16 hole into the wall Table Top AlarmWall Battery Installation Battery Installation and OperationBattery Back-up Operation in Low Battery Lb Condition Battery Backup OperationBattery Backup Operation Battery Back-up Operation inTrouble Alarm ConditionPage Normal Operating Characteristics OperationTesting the Electronics Malfunction Signal Group 2 Microprocessor Failure If the alarm malfunctionsMalfunction Signal Group 1 Component Failure What to do if you’re not sureHow to Care for Your Alarm Alarm from the electrical outlet before vacuumingTo Reset the Peak Level Memory… Peak Level MemoryWhat You Should Not Do Home Safety Tips What You Can DoCarbon Monoxide Never use a gas range, oven, or clothes dryer for heatingClues You Cannot See Loose or disconnected vent/chimney, fireplace or applianceUnderstand the Effects of Carbon Monoxide Exposure Common Medium Exposure Symptoms What To Do When the Alarm SoundsCommon Mild Exposure Symptoms Common Extreme Exposure SymptomsCall your emergency services If alarm signal sounds 4 quick chirps, 5 seconds offTion Specifications How the Unit Determines When to Alarm SpecificationsReplacement of Alarm AC and DC Start Up, Alarm and Error Operation Display ReadingsAC Powered in Normal Stand-by Operation DC Powered in Battery Backup OperationLi-Ion Battery Handling Precautions Detect COBattery Storage When Detached From the Alarm Limited Warranty For Warranty Service Please send products and all other correspondence to
Top Page Image Contents