Kidde KN-COPP-3-RC manual Where Not to Install Your CO Alarm, AT Least 5 feet away from appliance

Page 12

Installation

Where Not to Install Your CO Alarm

To avoid causing damage to the unit, to provide optimum protection, and to prevent unnecessary alarms, follow the directions below :

It is recommended that you do not install this CO alarm in garages, kitchens or furnace rooms. Installation in these areas could lead to nuisance alarms, may expose the sensor to substances that could damage or contaminate it, or the alarm may not be heard by persons in other areas of the home, especially if they are sleeping.

In the garage, vehicle exhaust can contain some carbon monoxide. These levels are higher when the engine is first started. Within hours of starting a vehicle and backing it out of the garage, the levels present over time can activate the alarm and become a nuisance.

In the kitchen and furnace room, some gas appliances can emit a short burst of carbon monoxide upon start-up. This is normal. If your CO alarm is mounted too close to these appliances, it may alarm often and become a nuisance.

If you must install a Carrier CO alarm near a cooking or heating appliance, install

AT LEAST 5 feet away from appliance.

Donotinstallinexcessivelydusty,dirtyorgreasyareassuchaskitchens,garages and furnace rooms. Dust, grease or household chemicals can contaminate or coat the alarm’s sensor, causing the alarm not to operate properly.

Do not obstruct the vents located at the top and bottom of the alarm. Place the alarm where drapes, furniture or other objects do not block the flow of air to the vents.

Donotinstall in dead air space, such as peaks of vaulted ceilings or gabled roofs, where carbon monoxide may not reach the sensor in time to provide early warn- ing.

Do not install in turbulent air from ceiling fans. Do not install near doors and win- dows that open to the outside, near fresh air vents, or anywhere that is drafty. Rapid air circulation from fans or fresh air from outside may cause the sensor to display an inaccurate reading in the presence of CO.

Do not install this alarm in a switch- or dimmer-controlled outlet.

Do not install in areas where the temperature is colder than 40˚F (4.4˚C) or hot- ter than 100˚F (37.8˚C). These areas include unconditioned crawl spaces, attics, porchesandgarages.Extremetemperatureswillaffectthesensitivityofthealarm.

Do not install COalarm near deep cell large batteries. Large batteries have emis- sions that can cause the alarm to perform at less than optimum performance.

9

Image 12
Contents Carbon Monoxide Table of Contents Page Quick Set Up Guide Setting up your alarm for first time operationQuick Set Up Guide Introduction Features Carrier CO Alarm front viewDigital Display Rear view with back door removed Pull-Out Transformer/AdapterWhat Carbon Monoxide Alarms Can and Cannot Do Installation Where to Install Your CO AlarmRecommended Locations Where Not to Install Your CO Alarm AT Least 5 feet away from applianceHow to Install Your Alarm Direct Plug AlarmTo install Avoid the followingWall Mounted Alarm Plug the alarm into an unswitched wall socketIf the outlet is mounted horizontally sideways To rotate the adapterTable Top Alarm Or drywall, drill a 3/16 hole into the wallWall Battery Installation Battery Installation and OperationBattery Backup Operation Battery Backup OperationBattery Back-up Operation in Low Battery Lb Condition Battery Back-up Operation inTrouble Alarm ConditionPage Normal Operating Characteristics OperationTesting the Electronics If the alarm malfunctions Malfunction Signal Group 1 Component FailureMalfunction Signal Group 2 Microprocessor Failure What to do if you’re not sureHow to Care for Your Alarm Alarm from the electrical outlet before vacuumingTo Reset the Peak Level Memory… Peak Level MemoryHome Safety Tips What You Can Do Carbon MonoxideWhat You Should Not Do Never use a gas range, oven, or clothes dryer for heatingLoose or disconnected vent/chimney, fireplace or appliance Clues You Cannot SeeUnderstand the Effects of Carbon Monoxide Exposure What To Do When the Alarm Sounds Common Mild Exposure SymptomsCommon Medium Exposure Symptoms Common Extreme Exposure SymptomsIf alarm signal sounds 4 quick chirps, 5 seconds off Call your emergency servicesTion Specifications Specifications How the Unit Determines When to AlarmReplacement of Alarm AC and DC Start Up, Alarm and Error Operation Display ReadingsAC Powered in Normal Stand-by Operation DC Powered in Battery Backup OperationLi-Ion Battery Handling Precautions Detect COBattery Storage When Detached From the Alarm Limited Warranty For Warranty Service Please send products and all other correspondence to