Kidde KN-COPP-3-RC manual AC Powered in Normal Stand-by Operation

Page 31

Display Readings

AC Powered in Normal Stand-by Operation

Display Shows

Alarm Sound

Unit Status

Unit Condition

Recommended

 

 

 

 

 

 

 

 

 

Action

 

 

 

 

 

 

 

 

 

 

 

 

 

 

“0” with

None.

Normal operation

Battery is fully

None.

 

 

 

 

flashing dot.

sensing for CO.

 

charged.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

“0” alternat-

None.

Charging battery

 

Battery dis-

Keep unit on

Flashes

ing with “Lb”

 

pack. Initial

 

charged less

AC to fully

and a flashing

power-up or

 

than 10 hours

charge battery.

alternately

dot.

 

 

 

power was reset.

 

on AC. Battery

“Lb” will disap-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

is in charge

pear once bat-

 

 

 

 

 

 

 

 

state.

tery is charged

 

 

 

 

 

 

 

 

 

depending on

 

 

 

 

 

 

 

 

 

initial charge.

 

 

 

“0” alternat-

1 beep every

Battery discon-

 

Battery dis-

Connect battery

 

 

 

ing with

15 seconds.

nected or not

 

charged or dis-

pack. “Lb” will

 

 

 

“Lb” and a

 

charging.

 

connected

disappear once

 

 

 

flashing dot.

 

 

 

longer than 10

battery is

 

 

 

 

 

 

 

 

hours.

charged

 

 

 

 

 

 

 

 

 

depending on

 

 

 

 

 

 

 

 

 

initial charge.

 

If at any time you test the alarm and it does not perform as described, have it replaced immediately.

DC Powered in Battery Backup Operation

Display Shows

Alarm Sound

Unit Status

Unit Condition

Recommended

 

 

 

 

 

Action

 

 

 

 

 

 

“0”.

None.

Operation on

 

Battery is fully

Connect to AC

 

 

battery backup,

 

charged. First 5

power.

 

 

sensing for CO.

minutes on battery

 

 

 

 

backup

 

“0” or CO

None.

concentration

 

displayed

 

once every

 

60 seconds;

 

flashing dot.

 

Battery conserve

Battery is fully

Normal battery-

mode, sensing

charged and after

only operation.

for CO.

5 minutes of

To recharge

 

operation on

battery connect

 

battery backup.

to AC power.

“0” or CO

None.

Battery conserve

Battery is partially

Connect to AC

concentration

 

mode, sensing

discharged, first 5

power to fully

alternating

 

for CO.

minutes of operation

recharge bat-

with “Lb”.

 

tery.

 

 

on battery backup.

 

 

 

 

27

Image 31
Contents Carbon Monoxide Table of Contents Page Setting up your alarm for first time operation Quick Set Up GuideQuick Set Up Guide Introduction Carrier CO Alarm front view FeaturesDigital Display Pull-Out Transformer/Adapter Rear view with back door removedWhat Carbon Monoxide Alarms Can and Cannot Do Where to Install Your CO Alarm InstallationRecommended Locations AT Least 5 feet away from appliance Where Not to Install Your CO AlarmAvoid the following How to Install Your AlarmDirect Plug Alarm To installTo rotate the adapter Wall Mounted AlarmPlug the alarm into an unswitched wall socket If the outlet is mounted horizontally sidewaysOr drywall, drill a 3/16 hole into the wall Table Top AlarmWall Battery Installation and Operation Battery InstallationBattery Back-up Operation inTrouble Alarm Condition Battery Backup OperationBattery Backup Operation Battery Back-up Operation in Low Battery Lb ConditionPage Operation Normal Operating CharacteristicsTesting the Electronics What to do if you’re not sure If the alarm malfunctionsMalfunction Signal Group 1 Component Failure Malfunction Signal Group 2 Microprocessor FailureAlarm from the electrical outlet before vacuuming How to Care for Your AlarmPeak Level Memory To Reset the Peak Level Memory…Never use a gas range, oven, or clothes dryer for heating Home Safety Tips What You Can DoCarbon Monoxide What You Should Not DoClues You Cannot See Loose or disconnected vent/chimney, fireplace or applianceUnderstand the Effects of Carbon Monoxide Exposure Common Extreme Exposure Symptoms What To Do When the Alarm SoundsCommon Mild Exposure Symptoms Common Medium Exposure SymptomsCall your emergency services If alarm signal sounds 4 quick chirps, 5 seconds offTion Specifications How the Unit Determines When to Alarm SpecificationsReplacement of Alarm Display Readings AC and DC Start Up, Alarm and Error OperationDC Powered in Battery Backup Operation AC Powered in Normal Stand-by OperationDetect CO Li-Ion Battery Handling PrecautionsBattery Storage When Detached From the Alarm Limited Warranty Please send products and all other correspondence to For Warranty Service