Operating and Installation Instructions
CO, Smoke/CO Combination, heat, etc.). This Smoke/CO combination alarm must be counted as a smoke alarm when determining the number of units on an intercon- nect line. With 18 alarms interconnected, it is still possible to interconnect up to a total of 6 remote signaling devices and /or relay modules (see page 15 for details on interconnecting Kidde devices).
•The maximum wire run distance between the first and last unit in an interconnected system is 1000 feet.
•Figure 3 illustrates interconnection wiring. Improper con- nection may result in damage to the alarm, failure to operate, or a shock hazard.
FUSE OR CIRCUIT BREAKER
BLACK | RED | BLACK | RED |
WHITE |
| WHITE |
|
| CONNECTOR | Kidde | CONNECTOR |
|
| Relay Module |
|
First | Additional | SM120X | Additional |
| |||
Ala | rm Ala | Optional Accessory | rm Ala |
FIGURE 3 Interconnect Wiring Diagram
WIRES ON ALARM HARNESS CONNECTED TO
Black | Hot side of AC line |
White | Neutral side of AC line |
Red | Interconnect lines (red wires) of other |
| units in the multiple station set up |
•Make certain alarms are wired to a continuous (non- switched) power line. NOTE: Use standard UL Listed household wire (as required by local codes) available at all electrical supply stores and most hardware stores
Step 3 Mounting Instructions
CAUTION: YOUR SMOKE/CO ALARM IS SEALED AND THE COVER IS NOT REMOVABLE!
1.To help identify the date to replace the unit, a label has been affixed to the side of the alarm. Write the “Replace by” date (7 years from initial power up) in permanent marker on the label. See Alarm Replacement section for additional information.
12