Kidde KN-COPE-I manual Industry Safety Standards, California State Fire Marshall

Page 31

Industry Safety Standards

NFPA (National Fire Protection Association)

For your information, the National Fire Protection Association’s Standard 72, reads as follows:

Smoke Detection. Where required by applicable laws, codes, or standards for the specified occupancy, approved single- and multiple-station smoke alarms shall be installed as fol- lows: (1) In all sleeping rooms Exception: Smoke alarms shall not be required in sleeping rooms in existing one- and two- family dwelling units. (2) Outside of each separate sleeping area, in immediate vicinity of the sleeping rooms. (3) On each level of the dwelling unit, including basements Exception: In existing one- and two-family dwelling units, approved smoke alarms powered by batteries are permitted.

Smoke Detection–Are More Smoke Alarms Desirable? The required number of smoke alarms might not provide reliable early warning protection for those areas separated by a door from the areas protected by the required smoke alarms. For this reason, it is recommended that the house- holder consider the use of additional smoke alarms for those areas for increased protection. The additional areas include the basement, bedrooms, dining room, furnace room, utility room, and hallways not protected by the required smoke alarms. The installation of smoke alarms in kitchens, attics (finished or unfinished), or garages is not normally recommended, as these locations occasionally experience conditions that can result in improper operation.

California State Fire Marshall

Early warning fire detection is best achieved by the installa- tion of fire detection equipment in all rooms and areas of the household as follows: A smoke alarm installed in each separate sleeping area (in the vicinity, but outside the bed- rooms), heat or smoke detectors in the living rooms, dining rooms, bedrooms, kitchens, hallways, attics, furnace rooms, closets, utility and storage rooms, basements and attached garages.

26

Image 31
Contents Photoelectric Smoke and Carbon Monoxide Alarm If alarm signal sounds Operate the test/reset button What To Do When The Alarm Sounds Actuation of your CO AlarmAfter following steps Never Ignore the Sound of the Alarm What To Do When The Alarm SoundsWhat To Do When The Alarm Sounds Table of Contents Introduction Light Emitting Diode Alarm SounderBattery Compartment Product ViewBack Features Features Smoke Alarm Smoke Alarm FeaturesCarbon Monoxide CO Alarm Carbon Monoxide Alarm FeaturesRecommended Installation Locations Step Installation GuideMobile Homes Sloped Ceiling InstallationWhere Not to Installfor use in ordinary indoor locations Wiring Instructions for AC Quick Connect HAR- Ness Step Wiring Instructions Wiring RequirementsMounting Instructions Wires on Alarm Harness Connected toOperating and Installation Instructions Interconnect Feature Testing the AlarmHush Control Feature LED Indicator Operation Red LED Reset FeatureLow Battery Hush Control Alarm/Peak Level MemoryGreen LED Tamper Resist FeaturesPosts Alarm Removal CO Alarm Response TimeBattery Replacement Alarm Replacement General MaintenanceGeneral Maintence Feature Description on page 17 for Removal Instructions General CO Information Carbon Monoxide Safety InformationPossible Sources Symptoms of CO Poisoning CO Safety TipsEscape Plan Fire Safety InformationFire Prevention California State Fire Marshall Industry Safety StandardsConsumer Product Safety Commission Warranty and Service Information Warranty and Service Information Questions or for More Information