Kenmore 251.90701 Error Type Possible, Code, Corrective Actions, Classification Spec, Setup Guide

Error	Error Type	Possible			Causes
Code
E0	Temperature
	Sensor	1.	Sudden		change
E 1	Defrost		in the
			surrounding
	Sensor		temperature.
E2	Humidity	i2.	Faulty	sensor.
	Sensor
E3	Pump Drain	1. Improper
			bucket
			installation.
		2.	Blockage			to
			drain	hose
			system.
		3.	Back	flow		of
			water	through
			pump	drain
			hose.
		4. Improper				pump
			drain	hose
			installation.
		5.	Faulty	drain
			pump.

Corrective Actions

1.Unplug the dehumidifier.

2.Check the surrounding area for possible reasons for sudden temperature changes.

3.Wait 30 minutes before plugging the dehumidifier back in and resuming normal operation.

4.If the "Error" is still indicated, please contact your nearest service center.

1.Unplug the dehumidifier.

2.Remove the bucket.

3.Check to make sure that there is nothing blocking the connection at the base of the pump or the bucket.

4.Reinstall the bucket, taking care that it is installed properly.

5.Check to make sure that the pump drain hose is not crimped or blocked.

6.Check to make sure that the pump drain hose is not both under water and sitting at

a height above the dehumidifier - this can cause a "back flow" of water from the hose to the dehumidifier.

7.Remove and reinstall the pump drain hose, taking care that the pump drain hose is installed properly.

The remote monitoring station is a receiver with a receiving range of only 330 feet in open air with no obstructions. Actual receiving range will vary depending on what is in

the path of the signal transmitted from the dehumidifier unit. Each obstruction (roof, walls, floors, ceilings, thick trees, etc.) will effectively cut signal range in half.

Example: The wireless remote monitor with a 330-foot range is mounted on an interior walt or placed on a countertop so the signal from the dehumidifier has to pass through one basement wall, across the 10-foot width of the

will reduce the range to 165 feet, and the second walt will reduce the range to 87 feet. Factoring in the 10-foot room, this leaves

a maximum of 77 feet of remaining signal range. Passing up through the floor has now reduced the effective range to 38 feet.

Typically this allowance is enough for most flame-constructed homes; however certain materials can reduce range even further.

Metal siding, stucco, and some types of glass can reduce signal range by as much as 75% compared to the 50% reduction typical d most obstructions. It is possible to receive a signal through these materials; however maximum range will be much less, due to their tendency to absorb or reflect

a much larger portion of the dehumidifier's signal.

8.Plug the dehumidifier in and restart

9.If the "E3" error is still indicated, please contact your nearest service center.

room through the room'sother watt and then

through the floor to the room upstairs where the receiver is located. The first wall

NOTE: You may have to move the monitor closer to the main unit if it is not receiving a proper signal following set-up procedures.

Classification		Spec				Remark
Model		251.90701
Power Supply		AC 115V/60(Hz)
Moisture	Removal	70 Pint(33.11iters)				24-Hour	Period
Control Type		Electronic
Refrigerant		R410A/11.29 oz.				320g
Humidity		Humidity Setting: 35%-70%				5% Increments
Display		Display Range: 20%-90%				1% Increments.		Current	Humidity.
Temperature		Display	Range:	Lo, 36-99°F,	Hi	1° F Increments.		Current	Temp.
Display		Display	Range:	Lo, 2-37°C,	Hi	1° C Increments.		Current	Temp.
Timed Shut-off		Setting Range: 1Hr-12Hr				1 Hour	Increments
Fan Motor Speed		3 Speeds				Auto/High/Low
Dimensions		15.74x25.59x13.6		in		400x650x346mm
Net Weight		49 lbs				22.3Kg
Operating	Temp.	36°F-99°F
Drain Pump		12V DC
Pump Drain Hose		.25 in x 18 ft				6.35x5,486mm

Setup Guide

Insert the batteries in the monitor. After the batteries are inserted, the Monitoring Station will start receiving signal data from the dehumidifier: temperature, humidity, etc. should be displayed on the monitor's screen. If this doesn't happen after 2 minutes, check the dehumidifier to make sure it is operating properly. Remove the batteries from the monitor, wait a minute, then replace.

Batteries

® j

OPE_ATI G	BUCKH	PUM	@	Receiver On
			@	BatteryStrength
_o'		AUTO	Q	SoundAlert
TEMPErATUrE		H_MIOITY		Time of Day
Qn		Ul,
				Fan On
.;tU		I		Bucket Full
			@	Pump On
				Temperature
			@Hurnidity
				Wall Hanger
				Set Button
				Minus
			O	Plus
				Sound On/Off

10

11