Gas Supply Requirements

Recommended Ground Method

The outdoor side burner, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code ANSI/NFPA 70, or Canadian Electrical Code, CSA C22.1.

Copies of the standards listed above may be obtained from:

CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

National Fire Protection Association

One Batterymarch Park

Quincy, Massachusetts 02269

A. 3 prong ground plug

B. 3-prong polarized type outdoor GFI outlet

C. Ground prong

WARNING

Explosion Hazard

Use a new CSA International approved “outdoor” gas supply line.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Gas Conversion:

No attempt shall be made to convert the side burner from the gas specified on the model/serial rating plate for use with a different gas type without consulting the serving gas supplier. The conversion kits specified must be used.

Gas Pressure Regulator

The gas pressure regulator supplied with this side burner must be used. The inlet (supply) pressure to the regulator should be as follows for proper operation:

LP Gas:

Set pressure: 11" (27.9 cm) WCP

Inlet (supply) pressure: 11" to 14" (27.9 cm to 35.5 cm) WCP

Natural Gas:

Set pressure: 4" (10.2 cm) WCP

Inlet (supply) pressure: 7" to 14" (17.8 cm to 35.5 cm) WCP maximum.

Contact local gas supplier if you are not sure about the inlet (supply) pressure.

Burner Requirements for High Altitude

Input ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m).

For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level. Orifice conversion is required. See “Assistance or Service” section to order.

Gas Supply Line Pressure Testing

Testing above ½ psi (3.5 kPa) or 14" (35.5 cm) WCP (gauge):

The side burner and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures greater than ½ psig (3.5 kPa).

Testing below ½ psi (3.5 kPa) or 14" (35.5 cm) WCP (gauge) or lower:

The side burner must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psig (3.5 kPa).

Natural Gas:

Side burners are equipped for use with Natural gas. They are design-certified by CSA International for LP (propane or butane) gases with appropriate conversion.

Side burners are set for natural gas use and have a pressure regulator with ¹⁄₂" (1.3 cm) female pipe threads.

Observe all governing codes and ordinances.

IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 - latest edition or CAN/CGA B149.1 - latest edition.

IMPORTANT: The side burner must be connected to a regulated gas supply.

Refer to the model/serial rating plate for information on the type of gas that can be used. If this information does not agree with the type of gas available, check with your local gas supplier.

A. Rear side of burner

B. ¹⁄₂" (1.3 cm) side burner gas pipe

C. New CSA approved outdoor flexible gas supply line

KBZU242TSS specifications

The KitchenAid KBZU242TSS is a standout choice for those looking to elevate their kitchen experience with top-tier performance and style. Designed with a focus on functionality, this under-counter refrigerator offers both convenience and sophistication, making it an ideal addition to any modern kitchen or entertainment area.

One of the key features of the KBZU242TSS is its spacious 5.5 cubic feet capacity. This appliance provides ample storage space to accommodate a variety of items, whether you’re stocking up on beverages, snacks, or ingredients for your culinary creations. The adjustable shelves allow for customizable storage solutions, enabling users to configure the interior to their liking, maximizing both organization and accessibility.

The refrigerator boasts a sleek stainless steel finish that enhances the aesthetic appeal of your kitchen. Its front door features a true flush installation, allowing the appliance to blend seamlessly with cabinetry for a built-in look. This design not only adds to the visual appeal but also ensures that the unit is space-efficient, making it suitable for smaller kitchens or areas where every inch counts.

Equipped with advanced cooling technology, the KBZU242TSS utilizes a cooling system that maintains consistent temperatures to preserve the freshness of your food items. The temperature control settings are user-friendly, allowing you to adjust the cooling levels for different types of content stored within the refrigerator. The interior LED lighting illuminates the contents, making it easy to find what you need, even in low light conditions.

The KBZU242TSS also features a door alarm, which alerts you if the door has been left ajar for an extended period. This ensures that the internal temperature remains optimal, preventing spoilage and food waste. Additionally, the unit operates quietly, making it a suitable addition to any space without disruptive noise.

Furthermore, the easy-to-clean surfaces and removable shelves ensure that maintaining this under-counter refrigerator is a hassle-free experience. Overall, the KitchenAid KBZU242TSS combines thoughtful design and advanced technology, making it an excellent investment for those looking to enhance their kitchen functionality while maintaining a stylish and organized space.