Bosch Appliances Boiler System 1 Setup and Programming, Initial setup, Additional information

16 Bosch Greenstar Applications Manual

System 1: Setup and Programming

In this single zone system the FW200 is installed in the living space in a location that represents the conditions of the entire zone. Avoid locations exposed to direct or indirect sunlight, heat sources, draft, etc. that can lead to over compensation.

Initial setup:

See the installation instructions for description of buttons and displays, and for details on setup and programming.

Power up the boiler.

When commissioning for the first time set the display language, date and time.

Upon first commissioning the automatic system configuration starts. Wait 60 seconds and follow the instructions displayed. You have the option of using the factory settings or entering custom parameters to better match the individual requirements.

Set up the weekly heating program for the three available temperature levels:

—Comfort

—Economy

—Frost (Frost protection)

Take advantage of using one of the preset programs from the list or enter a custom program.

—Program A

—Program F

—AM weekday worker

—PM weekday worker

—All day

—All day, lunch

—Family

—All day, early shift

—All day, late shift

—Seniors

Set the room temperatures for the three specified temperature levels.

Enter the installer menu to configure the heating zone.

—Set heating circuit type to Baseboard.

—Set the minimum outdoor temperature, building storage capacity, design day temperature, and maximum supply temperature.

—Set the room influence followed by the remaining parameters as they apply to the system.

When done, ensure the mode selector is set to AUTO.

The room temperature will be displayed.

Additional information:

With outdoor reset the boiler will provide the water tem- perature according to the heating curve adjusted by the level of room influence (if enabled).

The boiler will always attempt to run at its highest efficiency in low fire for as long as necessary.

The boiler will shut down when the target temperature is reached followed by a 3 minute post purge by the pump.

—The boiler and the pump will start again when the supply water temperature drops 18°F (10°C) below the set point.

Data subject to change Bosch Thermotechnology Corp.