Keating Of Chicago 2000 user manual Cleaning, Griddle Surface

A. Griddle Surface

With proper care, the MIRACLEAN® surface and its unique cooking properties will last for many years. However, nicks or dents in the griddle surface may

CLEANING

Proper care should be taken to fully clean the griddle on a regular basis.

cause the griddle surface to lift from the depressed area. If nicks are close together, the surface may raise and be torn when a spatula or scraper is used. Care should be taken, as the damage done is irreparable. See Figure 3-3 on page 4.

Damage done to the MIRACLEAN® surface is irreparable and is not covered under Keating Warranty.

WARNING

Disconnect all power

before servicing.

DISCONNECT ELECTRIC POWER SOURCE BEFORE CLEANING.

A.CONTROL PANEL - Clean any grease build-up on the switches and thermostat knobs.

NOTE: If grease gets into the body of the switch or thermostat, it may cause it to fail.

B. Limited Calibration for 208-240 Volt Units (Less than 50°F difference)

You will need: One standard flat blade screwdriver

One accurate griddle thermometer

1.	Set thermostat to 300°F.
2.	Allow thermostat to cycle three times.
3.	Locate inverted “V” on front of griddle plate above
	to locate thermostat bulb position. Place

WARNING
Gas	Burns Shock
Improper installation
can cause damage,
injury or death.

IF GREASE GETS INTO THE BODY OF THE SWITCH OR THERMOSTAT, IT MAY CAUSE ELECTRICAL SHOCK.

B.CABINET - The front, back and sides of the cabinet should be kept clean for sanitary and safety reasons.

thermometer on plate over bulb half way toward

rear of griddle.

Figure 4-1

Thermostat calibration

4.If calibration of griddle is found to be less than 50°F off, simply loosen four dial plate retaining screws (See Figure 4-1), rotate dial plate to match thermometer reading and tighten screws.

NOTE: Calibration is not covered under warranty.

See page 5 “Cleaning the Griddle”

6