Desa RP30D, CGP20 Operating Heater, For Your Safety Read Before Lighting, Lighting Instructions

BLUE-FLAME CGP20, CGP20L AND RP30D

VENT-FREE PROPANE/LP GAS HEATER

CHECKING GAS

CONNECTIONS	Control Valve Location
Continued
Propane/LP
Supply Tank

Manual

Shutoff

Valve

Figure 15 - Checking Gas Joints

4. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation in the first column. If you don’t smell gas, go to the next step.

5. Press in control knob and turn coun-
terclockwise	to the PILOT
position. Keep control knob pressed
in for five (5) seconds (see Figure 16).
Note: You may be running this
heater for the first time after hook-
ing up to gas supply. If so, the con-
trol knob may need to be pressed in
for 30 seconds. This will allow air to
bleed from the gas system.
• If control knob does not pop up
when released, contact a qualified
service person or gas supplier for
repairs.
6. With control knob pressed in, push
down and release ignitor button. This

OPERATING

HEATER

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions ex- actly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information above.

2.Make sure manual shutoff valve is fully open.

3. Turn control knob clockwise Clockwise to the OFF position.

Ignitor Button	Control Knob
LOW	PILOT
	OFF
HIGH
IGNITOR

Figure 16 - Control Knob In The OFF Position

will light pilot. The pilot is attached

to the front of burner. The burner

and pilot are located behind the heat

shield. If needed, keep pressing igni-

tor button until pilot lights.

Note: If pilot does not stay lit, refer

to Troubleshooting, pages 12 through

14. Also contact a qualified service

person or gas supplier for repairs.

Until repairs are made, light pilot

with match. To light pilot with match,

see Manual Lighting Procedure,

page 11.

Thermocouple	Ignitor Electrode
	Pilot Burner

Figure 17 - Pilot

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot goes out, repeat steps 3 through 7.

Continued

10 103569