OWNER’S MANUAL
INSTALLATION
Bottom Log (#1)
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re-
Burner
Port
Grate
Chassis 
Burner
Figure 17 - Installing Bottom Log (#1)
Top Log (#2)
Peg
Figure 19 - Installing Top Log (#2)
position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place bottom log (#1) on grate to fit as illustrated in Figure 17. Make sure open areas of log set line up with burner ports (see Figure 18). Log will fit securely on chassis. IMPORTANT: Make sure log does not cover any burner ports.
2.Facing front of unit, place top log (#2) onto the pegs in the center of the bot- tom log (see Figure 19).
3.Position log piece (#3) by aligning holes on underside with remaining pegs on bottom log (see Figure 20).
4.Place lava rock around base of heater.
Burner | Log Piece (#3) |
Logs | |
Ports |
|
| Peg |
Figure 18 - Installing Log set (Top View)
Figure 20 - Installing Log Piece (#3)
104675 | 13 |