Niles Audio ZR-6 manual Paging, Party or Whole House Mode

SYSTEM CONFIGURATION

CONFIGURING THE ZR-6 MULTIZONE RECEIVER

The numbers represent the 6 zones of the ZR-6 MultiZone Receiver. A cursor will be blinking under the number“1” or "Zone 1."

Press the + button and the - button to toggle the cursor between the zones. The cursor blinks under the zone number when it is highlighted. Press the Band button to toggle “Y” on or off in the highlighted zone. Zones with “Y” present will be linked.

1

2

3

4

5

6

L

I

N

K

I

N

G

Y

Y

M

A

S

T

E

R

NOTE: IN THIS EXAMPLE ZONES 1 AND 2 ON THE MASTER ARE LINKED.

After “6” on the Master, it will toggle back to “1” on the fi rst connected Slave. After “6” on the last connected Slave, it will toggle back to “1” on the Master.

Repeat these steps until all of the desired zones have been linked.

1

2

3

4

5

6

L

I

N

K

I

N

G

Y

Y

Y

Y

S

L

A

V

E

1

To continue to the next system confi guration step, Paging, press the Set button once. To save the settings and exit the confi guration mode, simultaneously hold down the Band and Set buttons.

After the ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE] appears on the display. The ZR-6 will return to the normal operating mode.

PAGING

By default, all zones are enabled for paging (Figure 10). If there are zones where the end-user does not want to hear a page, follow these steps.

While in the confi guration mode (see above), press the Set button until [123456 PAGE MASTER] shows in the display. A “Y” appears below every zone number. A cursor will be blinking under the number “1” or "Zone 1."

1	2	3	4	5	6	P	A	G	E
YY		Y	Y	Y	Y	M	A	S	T	E	R

Press the + button or - button to toggle the cursor between the zones. The cursor under the zone number blinks when a zone is highlighted.

Press the Band button to toggle the “Y” on or off in the highlighted zone. Paging is enabled in all zones with a “Y”

1	2	3	4	5	6			P	A	G	E
Y		Y		Y		M	A	S	T	E	R

NOTE: IN THIS EXAMPLE ZONES 1, 3 AND 5 HAVE PAGING ENABLED.

After “6” on the Master, it will toggle to “1” on the fi rst connected Slave. After “6” on the last connected Slave, it will toggle back to “1” on the Master.

Repeat these steps until all of the desired zones have been set for the desired paging operation.

To continue to the next system confi guration step, Party or Whole House Mode, press the Set button once.

To save the settings and exit the confi guration mode, simultaneously hold down the Band and Set buttons. After the ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE] appears on the display. The ZR-6 will return to the normal operating mode.

PARTY OR WHOLE HOUSE MODE

This feature lets the end-user press-and-hold any Source Selection button for three seconds to turn on the entire house to the same source for a party. It also allows for the press-and- hold of the Off button to turn off the entire system from one zone keypad without the need to walk around to every keypad to do so. By default all zones will respond to Party mode. If there are zones that the end-user does not want to turn on when a press-and-hold is initiated, follow these steps.

NOTE: THIS FEATURE ONLY DEACTIVATES THE PRESS-AND-HOLD TURN- ON AND NOT THE TURN-OFF. THE PRESS-AND-HOLD TURN-OFF

IS ALWAYS AVAILABLE AT ANY KEYPAD REGARDLESS OF THIS SETTING.

While in the confi guration mode (see above), press the Set button until [123456 PARTY MASTER] shows in the display. The numbers represent the 6 zones of the ZR-6 MultiZone Receiver. A cursor will be blinking under the number “1” or "Zone 1."

1	2	3	4	5	6	P	A	R	T	Y
YY		Y	Y	Y		M	A	S	T	E	R

(CONTINUED ON NEXT PAGE)

36 NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373