Hearth and Home Technologies MBK, PMH installation instructions Yosemite, Important Safety Notes

Page 1

R

Yosemite

Non-Catalytic, Front/Side Load, Wood Heater

Models:

YOSEMITE-MBK YOSEMITE-PMH

Tested and

O-T L

Portland

Listed by

Oregon USA

CUS

OMNI-Test Laboratories, Inc.

This manual contains instructions for Installation, Operation & Maintenance.

Please read this entire manual before you install and use your new room heater. Failure to follow

instructions may result in property damage, bodily injury, or even death.

IMPORTANT SAFETY NOTES:

1)When installing your stove, particular attention should be paid to fire protection. If this room heater is not properly installed, a house fire may result. To reduce the risk of fire, follow the installation instructions. Contact local building or fire officials or authority having jurisdiction about restrictions, installation inspection and permit requirements in your area.

2)CAUTION: Never use gasoline or gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in this heater. Keep all such liquids well away from heater while it is in use.

3)During operation, if any part of the stove starts to glow, the stove is in an overfired condition. Close the air controls completely until the glowing has stopped. OVERFIRING VOIDS YOUR WARRANTY!

4)Cool ashes should be disposed of carefully, using a metal container.

5)Do not burn wet or green wood. Store wood in a dry location.

6)DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPHTHA OR ENGINE OIL. Do not burn treated wood, or wood with salt (driftwood, etc.). Burning materials other than wood (including charcoal) under adverse conditions may generate carbon monoxide in the home, resulting in illness or possible death.

7)Do not permit creosote or soot to accumulate excessively in the chimney or inside the firebox.

8)Check your chimney system thoroughly when installing into an existing metal or masonry chimney. Seek professional advice if in doubt about its condition.

9)Do not connect this unit to a chimney flue already serving another appliance.

10)Comply with all minimum clearances to combustibles as shown in this manual for this appliance.

11)Build fire on brick firebox floor. Do not use grates, andirons or other methods to support fuel.

12)HOT WHILE IN OPERATION! Keep children, pets, clothing and furniture away. Contact can cause skin burns.

13)Do not connect to any air distribution duct or system.

14)RISK OF FIRE! Do not operate with stove door open without the firescreen or with the ash removal system door open.

15)For further information refer to NFPA 211 (USA) or CAN/CSA-B365 (Canada).

16)Do not operate without fully assembling all components.

17)Do not operate with broken glass.

PRIOR TO FIRST FIRE: Remove all labels from glass. Clean plated surfaces with a glass cleaner and soft cloth

to prevent staining from fingerprint oils.

SAVE THESE INSTRUCTIONS

1445 North Highway

7004-187F September 1, 2008

www.quadrafire.com

Colville, WA 99114-2008

Page 1 Page 2
Image 1
Page 1 Page 2
Contents Yosemite Important Safety Notes007 Yosemite Wood StoveTable of Contents Chimney Systems Installation Materials Needed for Your SafetyVenting System Front View TOP View Rear Vent Vent SpecificationsSide View Side View with Fuel Door 90O Elbow OFF TOP of Stove Through Backwall Double Wall-USAFloor Protection Both Fuel Doors AccessibleSide Fuel Door Locked Shut USASide Fuel Door Locked Shut Corner Both Fuel Doors ACCESSIBLE- CornerHorizontal Venting Instructions to Unlock Side Fuel Door Locating Your StoveBolt fully extended Reversible Flue Collar Converting Collar for Rear Vent InstallationFlue Systems Chimney Height Requirements DraftMasonry Chimney Solid Pack Chimney with Metal Supports AS a Thimble Solid Pack Chimney with Metal Supports AS a Thimble Contd Connection to a Masonry FireplaceInterior Chimney Connection to a Metal Prefabricated ChimneySet off smoke alarms Mobile Home InstallationPart Outside AIR KIT InstallationSymptoms of Over-Firing Important Please Read Before Using StoveOperating Instructions Fire RiskPrimary AIR System AIR ControlsBTU / Hr Start-Up Air Control Primary Control Heat Output SettingsIncorrect Positions Correct Baffle & Blanket PlacementCorrect Position Burn Rates OpacityWood Selection and Storage Blower Operating InstructionsChimney Cleaning MaintenanceCreosote ASH RemovalGlass Replacement Maintenance ContdCare and Cleaning Plated Surfaces Door Handle Assemblies Glass Care ContdBaffle Removal & Installation Maintenance Brick Replacement InstructionsYosemite Wood Stove Service & Maintenance Log Yosemite Wood Stove Exploded Views Front Door Assembly Side Door AssemblySKU Service PartsCast Parts Individual Pieces CONDITIONS, Exclusions & Limitation of Liability Warranty PolicyHearth & Home Technologies Limited Warranty Contd Yosemite Wood Stove

MBK, PMH specifications

Hearth and Home Technologies (HHT) is a well-known name in the hearth industry, renowned for its commitment to innovation and quality in heating solutions. Their PMH and MBK series represent the pinnacle of modern wood-burning appliance technology, designed to meet varying consumer needs while prioritizing performance, efficiency, and environmental responsibility.

One of the standout features of the PMH (Performance Modular Home) line is its ability to blend seamlessly into a variety of home designs. It offers a sleek and contemporary aesthetic, making it a preferred choice for modern home builders. This series prioritizes efficient wood utilization, ensuring that users have a reliable source of sustainable heat. With high-efficiency ratings, the PMH units burn wood more thoroughly, leading to higher heat output with significantly reduced emissions.

Similarly, the MBK (Modular Built Kit) line excels in versatility and efficiency. Designed for modular homes, the MBK series provides a convenient solution for homeowners seeking efficient heating without compromising on style. These units are engineered to be space-saving, making them ideal for smaller living environments while still delivering impressive heat outputs. Their modular design allows for easy installation and maintenance, differentiating them from traditional wood stoves.

Both series incorporate advanced combustion technologies, which maximize fuel efficiency and reduce emissions. Features such as secondary combustion systems enhance the burning process, leading to cleaner emissions and lowering the environmental impact of wood heating. This is particularly vital in today’s eco-conscious market, where sustainability is a key consideration for consumers.

The HHT PMH and MBK series are equipped with various customization options, allowing homeowners to tailor their heating solutions to their specific requirements. Choices include different finishes, sizes, and control options, enabling users to create a hearth experience that aligns with their tastes and home decor.

In conclusion, Hearth and Home Technologies’ PMH and MBK series stand out for their blend of style, efficiency, and advanced technology. They not only provide reliable heating solutions but do so in a manner that respects the environment and meets the modern consumer’s desire for both functionality and design. For those seeking top-tier wood-burning technology, HHT’s offerings present a compelling choice worth considering.
Top Page Image Contents