Heartland The Artisan Understanding Combustion, Servicing, Fume Emission Warning, Fresh Air Kit

Page 17

Servicing

Always use a qualified service/heating engineer when servicing is required. Use only authorised replacement parts. Do not make unauthorised modifications.

Fume Emission Warning

Properly installed and operated, this stove will not emit fumes.

Occasional fumes from de-ashing and re-fuelling may occur but persistent fume emission must not be tolerated.

If fume emission does persist, then the following immediate action should be taken:-

a)Open doors and windows to ventilate room.

b)Let the fire out or remove lit fuel from cooker.

c)Check for flue or chimney blockage, and clean if required.

d)Do not attempt to relight fire until cause of fume has been identified, and if necessary, seek professional advice.

Part Number

Description

No. Req’d

1/16182 T

Bottomgrate bars top

6

1/16182 B

Bottomgrate bars bottom

5

3/16272

Oven side firebricks

2

4/16273

Firebox side top firebricks

1

3/16271

Front firebricks

1

3/18172

Grate Baffle

3

Please contact your Heartland dealer for information.

Fresh Air Kit

A fresh air kit enables you to use outside air, instead of room air to fuel the fire. Using an outside source for combustion air has its advantages. If your home is tight and well insulated, the fire in the stove may be “starved” of combustible air, it will be difficult maintaining a fire, and you may have back drafting problems.

During the heating season, cold air, (which is more dense than warm air), will cause the fire to burn a little hotter, resulting in more BTU’s from your wood, and less creosote build-up.Please contact an authorized Heartland dealer to purchase this option.

Understanding Combustion

Water: Up to half the weight of

freshly cut logs is water. After

proper seasoning only about 20% of the weight is water. As the wood is heated in the firebox, this water boils off, consuming heat energy in the wood, the more heat energy is consumed. That is why wet wood hisses and sizzles while dry wood

ignites and burns easily.

Smoke (or flame): As the wood heats up above the boiling point of water, it starts to smoke. The hydrocarbon gases and tars that make up the smoke are combustible if the temperature is high enough and oxygen is present. When the smoke

burns, it makes the bright flames that are characteristic of a wood fire. If the smoke does not burn, it will condense

in the chimney forming creosote or

exit the chimney as air pollution.

Charcoal: Asthe fire progresses and

most of the gases have vaporized, charcoal remains. Charcoal is almost 100% carbon and burns with very little flame or smoke. Charcoal is a good fuel that burns easily and cleanly when enough oxygen is present. Of the total energy content of the wood you burn, about half is in the form of smoke, and half is charcoal.

17

Image 17
Contents Save these instructions for future use ArtisanFor Your Safety Overfiring of this appliance will void warranty Consumer WarrantyTable of Contents Getting Acquainted WelcomeInstallation Installation Requirements Model Heartland Artisan Rough Measurements Clearances to Combustibles Single Wall Chimney ConnectorDimensions Dimensions Horizontal Connection Guidelines for Installing the Chimney ConnectorChimney Maintanence Chimney and draftFloor Protection Effect of Extractor FanGeneral Familiarise Yourself With Your StoveFuelling with Wood WoodburningLighting the Fire Door OperationTo Open and Close the Doors See Figure Below Do not slam the fire door shutRefueling Cleaning of Bottom GrateRestriction Plates De-AshingDirection of Flueway in Stove Chimney Sweeping Break-In FireFlue Chamber Damper Cleaning Flueway CleaningFirebrick Replacement To Replace Bottom Grate BarsServicing Understanding CombustionFume Emission Warning Fresh Air KitTo prevent overfiring Overfiring CautionChimneys and Draft Trouble ShootingHow Chimneys Work Factors That Effect DraftWhat To Do If You Have a Chimney Fire Safety PracticesFresh Air Kit