Operating Instructions and Parts Manual | Model EFL33 |
|
|
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
Description
An effluent system consists of a pump, control switch and a basin. The system is generally controlled by a float switch with a
The float switch is a wide angle differential switch that rises with the liquid level and turns the pump on. As the liquid level decreases, the float lowers and turns the pump off. This pump is intended for use in domestic sump or effluent lift stations. It is suitable for pumping effluent, wastewater, ground water and other nonexplosive, noncorrosive liquids with up to 3/4 inch solids.
Effluent pump will not pump raw
sewage or any substance exceeding 3/4 inch size.
Effluent Pump
Unpacking
Inspect this unit before it is used. Occasionally, products are damaged during shipment. If the pump or components are damaged, return the unit to the place of purchase for replacement. Failure to do so could result in serious injury or death.
Safety Guidelines
This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.
Danger indicates an imminently
hazardous situation which, if not avoided, WILL result in death or serious injury.
Warning indicates a potentially
hazardous situation which, if not avoided, COULD result in death or serious injury.
Caution indicates a potentially
hazardous situation which, if not avoided, MAY result in minor or moderate injury.
Notice indicates important
information, that if not followed, may cause damage to equipment.
General Safety Information
California proposition 65
This product or its power cord contains
chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
Specifications
Power supply requirements | 115V, 60 hz |
Circuit requirements | 15 amps (min) |
Motor duty | Intermittent |
Motor | 115V, 1 Phase, 1725 RPM |
Horsepower | 1/3 |
Motor full load | 11 amps |
Liquid temperature range | 40º F to 120º F |
Max. operating position | 45º from vertical |
Dimensions | |
Intake | 2 inch |
Discharge | 2 inch NPT female, 3 inch |
| NPT male |
18 inch | |
10 inch | |
Differential | 8 inch |
Switch | 90º wide angle |
| mechanical tether switch |
Power cord | 16 gauge 3 conductor |
| w/plug |
Construction
Motor body material | Cold rolled steel |
Motor housing | Glass reinforced |
| polypropylene |
Volute | Glass reinforced ABS |
Impeller | Glass reinforced PBT |
Seal plate | Cast Iron |
Shaft seal | End faced mechanical |
Performance
Gallons per hour at total head in feet
Model | 10 | 15 | 200 |
EFL33 | 3600 | 1300 | 0 |
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
© 2009 Wayne Water Systems | For parts, product & service information | |
| visit www.waynepumps.com |
|