CONTENTS |
|
| INTRODUCTION |
|
|
|
|
|
|
| ||||||
WaL'ranty | .............................................................................. | 2 | Please | read | our | instructions | before | installing | and | using | your | |||||
Pump | Performance | .............................................................. | 3 | pump. | This | will | help | you obtain | the | full benefits | of | the | qual- | |||
Major | Components |
| 3 | ity | and | convenience | binh | into | this | equipment. |
| It | will | also | ||
.............................................................. | help | you avoid | any | needless | service | expense | resulting | from | ||||||||
Piping |
|
| ||||||||||||||
................................................................................ | causes | beyond | our | control | which are not covered by our | |||||||||||
|
|
|
| |||||||||||||
Installation | 4 | waiTanty. |
|
|
|
|
|
|
|
|
|
|
| |||
Electrical | 5 |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Operation/Maintenance |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
Helpful | Hints | 9 |
|
|
|
|
|
|
|
|
|
|
|
|
| |
Troubleshooting | Guide | 10 |
|
|
|
|
|
|
|
|
|
|
|
|
| |
Repair | Parts | 11 |
|
|
|
|
|
|
|
|
|
|
|
|
| |
RULES FOR SAFE INSTALLATION AND OPERATION
1.Read the Owners Manual and Rules for Installation and
Safe Operation carefully. Failure to follow these Rules and
Instructions could cause serious bodily injury, and/or
property damage.
2.Check your local electrical wiring codes before installa- tion. ffyour local codes are not followed, your pump will not work to its full rated capacity and could present a fire hazard, ff in doubt, contact your local power company.
3.BE SURE your pump installation meets all local plumb- ing, pump and well codes.
4.While installing your pump, always keep the well covered to prevent leaves and foreign matter from falling into the
well, contaminating the water and/or causing possible se-
rious damage to the mechanical operation of the pump.
5.Always test the water from well for purity before using.
Check with local health department for testing procedure.
6.Before installing or servicing your pump, BE SURE pump power source is disconnected.
7.BE SURE your pump electrical circuit is properly grounded.
8.Complete pump and piping system MUST be protected
against below freezing temperature. Allov_mg the pump or piping to freeze could cause severe damage and voids the Warranty.
9.BE SURE the llne voltage and frequency of the electrical current supply agree with the motor wiring as shown on motor nameplate.
10.The correct fusing and vdring sizing is essential to proper
motor operation. Recommended fusing and wire size data is in the manual (Page 5).
11.Pump water only with this pump.
12.Periodically inspect pump and system components.
IA CAUTION 1Motor normally operates at high temperature and wilt be too hot to touch. It is protected
from heat damage during operation by an automatic inter-
nal cutoff switch. Before handling pump or motor, stop motor and allow it to cool for 20 minutes.