Niles Audio DS00356ACN Type of Speaker Wire, Tuner, Avoiding Interference, Tools Required

T A B L E T O P S T E R E O V O L U M E C O N T R O L

T A B L E T O P S T E R E O V O L U M E C O N T R O L

6.Insert each wire into the appropriate hole on the removable connector plug, and snap the locking tab down.

NOTE: To help you avoid improper installation, the connector plug is keyed.

Type of Speaker Wire

For most applications, we recommend you use 16 or 18 gauge, stranded copper speaker wire for the TVC-1 con- nections. For wiring runs longer than 80 feet, 14 gauge wire is recommended. Using speaker wire larger than 14 gauge for the TVC-1 connections is not recommended—the wire may not fit into the connectors. Never use solid-core, aluminum,

TOOLS

REQUIRED

• Wire Stripper

Receiver

TUNER 94.9

15

Niles Audio Corporation Miami, Florida USA

3/4 5/6

2AMPLIFIER

1

Figure 1

Wiring Diagram

Niles TVC-1

SPEAKER

or “Romex” type wire with the TVC-1. When running speaker wires inside walls, most states and municipalities in the U.S. specify that you must use a special type of speaker wire . Usually, the requirement is that the wire has a specific “CL” fire rating, such as “CL-2” or “CL-3”. Consult your Niles deal- er, building contractor, or local building and inspection department if unsure about which type of wire is best for your application.

Avoiding Interference

Speaker wires can act as an “antenna” for electrical noise. Locating speaker wires too close to a light dimmer or switch may cause a “buzzing” or "popping" sound to be heard

IMPORTANT

DO NOT use the TVC-1 with amps or receivers rated at more than 100

SPEAKER PAIRS

Speaker Pair

through the speakers. If you must locate the TVC-1 wiring near electrical devices, route the speaker wires several feet away from the electrical wiring.

watts per channel

RMS at 8 ohms.

7 4