Installation Checklist
BEFORELIGHTING THE PILOT:
1.Check the gas lines for leaks.
a.Use a soapy water solution. DO NOT test for gas leaks using a match or open flame.
b.Brush the soapy water solution on all gas pipes, joints and fittings.
c.Check for bubbling soap, This means you have a leak. Turn "OFF" gas and make the necessary repairs.
d.Recheck for leaks.
e.Rinse off soapy solution and wipe dry.
2.Is the new
installed and piped to an adequate drain? See
3.Are the cold and hot water lines connected to the
water heater correctly? See "Water Piping" instructions in the "Installing the New Water Heater" section.
4.Is the water heater completely filled with water? See
"Filling" instructions in the "Installing the New Water Heater" section.
5.Will a water leak damage anything? See the "Locating the New Water Heater" section,
6.Is there proper clearance between the water heater
and anything that might catch fire? See the "Locating the New water Heater" section.
7.Do you have adequate ventilation so that the
water heater will operate properly? See
"Combustion Air and Ventilation" in the "Locating the New Water Heater" section.
8.Is the draft hood vent piping properly secured? See
"Venting" instructions in the "Installing the New Water Heater" section.
9.Is there proper clearance between the vent pipe
and anything that might catch on fire? See
"Venting" instructions in the "Installing the New Water Heater" section.
10.Is the vent pipe properly sloped and does the vent terminate outdoors? See "Venting" instructions in the "Installing the New Water Heater" section.
11.Do you need to call your gas company to check the gas pipe and its hookup?
VENT PIPE TO | UNION | |
OUTDOORS | ||
| ||
OR CHIMNEY | SHUTOFF VALVE | |
| ||
HOT | COLD | |
|
DRAFT HOOD
GAS SUPPLY
SHUTOFF VALVE
TEE
DRIP LEG (Sediment trap)
PIPE CAP
DRAIN VALVE
DISCHARGE PIPE
(Do not cap or plug)
6 INCH AIR GAP
FLOOR DRAIN
14