lye Operation
DISCHARGE PIPE
WARNING
_n checking the
Jnd the outlet of the
fter manually operating the valve, it fails to complete-
eset and continues to release water, immedately ;e the cold water inlet to the water heater, follow the
ning instructions,and replace the
._relief valve with a new one.
'reto install and maintain a new properly listed
WARNING
hal expansion. Your water heater may have _ check
._installed in the water line or a water meter with a ck valve. Consult the SearsService Center for further
)rmation. Do not plug the
Draining
The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.
1.Turn the gas control knob to the "OFF" position.
2.CLOSE the cold water inlet valve to the water heater.
3.OPEN a nearby hot water faucet and leave open to allow for draining.
4.Connect a hose to the drain valve and terminate to an adequate drain.
5.OPEN the water heater drain valve to allow for tank draining.
NOTE: If the water heater is going to be shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to terminate to an adequate drain.
6.Close the drain valve.
7.Follow instructions in the "Filling The Water Heater" section.
8.Follow the lighting instructions in the "Lighting" section to restart the water heater.
Drain Valve Washer
Replacement
NOTE: For replacement, usea '%5"x "/," x %" thick washer available at your nearest hardware store. For ordering replacement washers,refer to the "Repair Parts" section.
1.Turn "OFF" gas supply to water heater.
2.Follow "Draining" instructions.
3.Turning counter clockwise, remove the hex cap below the screw handle.
4.Remove the washer and put the new one in place.
5.Screw the handle and cap assembly back into the drain valve and retighten using a wrench. DO NOT OVER TIGHTEN.
6.Follow instructions in the "Filling The Water Heater" section.
7.Check for leaks.
8.Follow the lighting instructions in the "Lighting " sec- tion to restart the water heater.
__HANDLEAND
nk (Sediment) Cleaning
ment
. In these cases Mag Erad(part no. 3515) can be used elp remove the sediment deposits. This may be red from the Sears Service Center. For ordering, refer e"Repair Parts" section.
Service
If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out. Call the Sears Service Center.
21