Troubleshooting (continued)
Others (continued)
Problem | Solution |
|
|
The fans sound during | • When Standby Mode in the Installation menu is set to LAN, Speaker Out, or Monitor |
standby. | Out, the fans rotate at very low speed during standby after plugging the power cord |
| (with 5 second high speed rotation at the beginning) and after turning off the lamp. |
| This is to cool down the projector operating various functions during standby and is |
| not a malfunction. |
Abnormal sound is | • Because the color wheel spins at a high speed, metallic sounds may be heard in rare |
heard. | occasions. Such symptom is not a malfunction. |
The interactive pen | • Set Interactive Mode in the Interactive Pen menu to Off and then set it to On again. |
does not work. (The |
|
communication |
|
between the projector |
|
and interactive pen |
|
isn’t established.) |
|
If the following problem occurs after the lamp is replaced, check the following first.
Problem | Solution | |
|
| |
The projector does not | • Fit the lamp cover securely. (See page 50 or 51.) | |
turn on. | • | Reset the lamp operating time. (See page 51.) |
|
|
|
The STATUS indicator | • | Reset the lamp operating time. (See page 51.) |
blinks. |
|
|
|
|
|
Maintenance
Warning:
Do not use flammable solvents (benzene, thinner, etc.) and flammable aerosols when cleaning the projector body and lens. Flammable substances may ignite causing fire or breakdown while the lamp is illuminating.
Caution:
Be sure to turn off the lamp and unplug the power cord from the wall outlet before you perform any maintenance on the projector.
Cleaning of the projector and the ventilation slots
Use a soft cloth to clean the projector and the ventilation grilles. When the grilles become dirty, wipe them with a soft cloth dampened with diluted mild detergent, and then wipe them with a dry cloth.
To protect the surface of the projector from fading or deteriorating:
•Do not spray insecticide on or inside the projector.
•Do not use benzin or thinner to clean it.
•Do not let rubber or plastic materials contact with projector.
Cleaning of the lens
Remove dust or dirt using the commercially available lens care products (such as cleaning paper or cloth for lens and blower brush).
•Since the lens surface is sensitive, do not scrub it with a solid object or tap on it.
•Do not wipe the lens with a lens cleaner. It may cause wipe marks or peel of the lens coating.
Kensington Lock
This projector has a Kensington Security Standard connector for use with Kensington MicroSaver Security System. Refer to the information that came with the Kensington System for instructions on how to use it to secure the projector. Please contact Kensington Technology Group below.
Kensington Technology Group 2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone: +1- | Fax: +1- |
