Mitsubishi Electronics WD385U-EST Restart of network function, Initialization of network settings

Network settings (continued)

•The number of characters of KEY varies depending on the Encryption setting.

•WEP 128bit(ASCII): 13 chars

•WEP 64bit(ASCII): 5 chars

•WEP 128bit(HEX): 26 digits

•WEP 64bit(HEX): 10 digits

•WPA-PSK(ASCII): 8-63 chars

•WPA2-PSK(ASCII): 8-63 chars

•WPA-PSK(HEX): 64 digits

•WPA2-PSK(HEX): 64 digits

•If the entered content is outside character number range, the KEY screen appears again after an error dialog is displayed.

Restart of network function

(See page 21 for menu setting.)

1.Display the Network Config menu.

2.Press the  or  button to select Network Restart.

Network Restart OK

3.Press the ENTER button.

•Network Restart dialog appears.

4.If the ENTER button is pressed again, the network function will be restarted.

•It may take some time to restart the function.

Wireless Setup setting

1.Display the Wireless Setting menu.

2.Press the  or  button to select Wireless Setup.

Wireless Setup OK

3.Press the ENTER button.

•Confirmation dialog appears.

4.If the ENTER button is pressed again, the Wireless Setting will be reflected.

•It may take some time to reflect the setting.

Enabling or disabling the AMX Device Discovery

Select this setting when using the AMX controller. (See page 21 for menu setting.)

1.Display the Network Config menu.

2.Press the  or  button to select AMX Device Discovery.

AMX Device Discovery Off

3.Press the ENTER button.

• AMX dialog appears.

AMX : OFF

OK : ENTER CANCEL : MENU

4.Press the  or  button to select ON or OFF .

5.Select the item to set, and press the ENTER button.

•To cancel the setting, press the MENU button.

•It may take some time to reflect the setting.

Initialization of network settings

(See page 21 for menu setting.)

1.Display the Network Config menu.

2.Press the  or  button to select Network Initialization.

Network Initialization OK

3.Press the ENTER button.

•Network Initialization dialog appears.

4.If the ENTER button is pressed again, the network settings will be initialized.

•It may take some time to initialize the settings.

How to use network function

•When connecting a computer and projector with

LAN, configure the both IP Addresses in the same network group.

If connecting in different network group, be sure to use a router. As for the settings of a router, ask the network administrator.

•Configure the IP Config correctly. If the settings are not correct, the communication may be unavailable. For the detail, consult the network administrator.

•Depending on the settings of Standby Mode of the projector, LAN function may be unavailable. See page 26 for the detail of Standby Mode.

Glossary

For more detail of the glossary below, refer to the technical book that is commercially available.

Term	Description
	Abbreviation for Dynamic Host
DHCP	Configuration Protocol. This
	protocol automatically assigns IP
	Address to networked devices.
IP Address	Numerical address to identify
	networked computers.
	A numeric value to define the
Subnet Mask	number of bits used for a network
	address of a divided network (or
	subnet) in an IP Address.
	A server (or router) to communicate
Default Gateway	across networks (subnets) that are
	divided by Subnet Mask.
	Abbreviation for Media Access
	Control Address. MAC Address is a
MAC Address	unique ID number assigned to each
	network adapter. And this is based
	on which data are sent and received
	between network adapters.

EN-37