Menu operation (continued)
Interactive Pen menu
|
|
|
| Interactive Pen | |||
|
|
|
|
|
|
|
|
Interactive Mode |
| Off | |||||
Dual Pen |
| Off | |||||
Pair New Device |
| OK |
|
| |||
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Adjust |
| MENU | Exit | |
|
|
| Select |
|
|
|
|
|
|
|
|
|
|
|
|
ITEM | SETTING | FUNCTION | ||
Interactive Mode | On / Off | Select On to operate the personal computer being connected to the projector | ||
|
|
|
| using the interactive pen. |
Dual Pen | On / Off | Select On to use two interactive pens at the same time. (The application | ||
|
|
|
| supporting Dual Pen is required.) |
Pair New Device | OK |
|
| When multiple projectors are used, use this setting to make the pair (of the |
|
| |||
|
|
|
| projector and the interactive pen) to prevent the pen from communicating |
|
|
|
| with other projectors unexpectedly. (See page 47.) (Even when the pair is |
|
|
|
| made, the projector can communicate with the other pen of which pairing |
|
|
|
| setting isn’t made.) |
•It takes few seconds to change the settings of Interactive Mode and Dual Pen in the menu.
•When Interactive Mode is turned On, projected colors change slightly. In addition, the contrast gets worse slightly.
•When Interactive Mode is turned On, the process such as switching the input takes more time than that during the normal mode.
•When Interactive Mode is turned On and the interactive pen is used, the entire process of the projector may take time.
However, it is not a product malfunction.
•You are recommended to use the interactive pen on the computer of which screen resolution is set to the same setting as the projector (1024 x 768 pixels for
•You cannot use the interactive pen while the interlace signal is displayed.
Information menu
| Information |
Lamp Time | 2000H |
Input | Computer1 |
Resolution | 1024x768 |
H. Frequency | 60.00 kHz |
V. Frequency | 60.00 Hz |
Sync. Type | 3Wire |
|
|
MENU
Exit
ITEM | DESCRIPTION |
Lamp Time | This menu shows a lamp operating time (hour) calculated assuming that Lamp Mode is Low. |
| • When the Lamp Mode is Standard, this menu shows a longer lamp operating time than the |
| actual time. (See page 51 for the interval of lamp replacement.) |
Input | Indicates the name of the terminal to which the currently projected video signal is being |
| inputted. |
Resolution | Indicates the resolution of the currently projected video signal. |
H. Frequency | Indicates the horizontal frequency of the currently projected video signal. |
V. Frequency | Indicates the vertical frequency of the currently projected video signal. |
Sync. Type | Indicates the type of the sync signal for the currently projected video signal. |
