Mitsubishi Electronics WD385U-EST user manual Menu operation

Menu operation

You can make various settings using the displayed menus.

Picture

Video Image

Image		Auto
		Theater
		Presentation
		Standard
		Black Board
		White Board		Brilliant Color™
		User		Gamma
Brightness		±30		Contrast R
Contrast		±30		Contrast G
Color Temp.		Low		Contrast B
		Mid		Brightness R
		High		Brightness G
		User		Brightness B
Color Management		Red		Gain
		Green		Saturation
		Blue		Hue
		Cyan
		Yellow
		Magenta
Aspect Ratio		Normal
		16:9	*7	Center, Upper, Lower	*8
		Full
Input Level		Auto, Normal, Enhanced
3D		Off, On
3D Sync Invert		Off, On
Color	*1	±10
Sharpness	*1	±5
Tint	*1	±10

0-10

Dynamic, Natural, Detail

±30

±30

±30

±30

±30

±30

±30

±30

±30

Signal

Audio

Installation

Option

H.Position			0-999		*4
V.Position			0-999		*4
Fine sync	*1*2		0-31
Tracking		*2	0-2800		*4
Computer Input		*2	Auto, RGB, YCbCr/YPbPr
Overscan			90-100%		*4
Hold		*2	On		Begin			0-99
			Off		End			0-99
User			OK		Clamp Position		*2	1-255
					Clamp Width		*2	1-63
					LPF	*1*2		On, Off
					Shutter(U)			0-20
Audio Input			Auto		Shutter(L)			0-20
					Shutter(LS)			0-20
			Audio 1	*6
					Shutter(RS)			0-20
			Audio 2	*6
			Audio 3	*6
			Mix	*6	±10
Volume			0-21

Menu Position	Upper Left, Upper Right, Center, Lower Left, Lower Right
Lamp Mode	Standard, Low
Standby Mode	Low, LAN, Speaker Out, Monitor Out
Image Reverse	Off, Mirror, Invert, Mirror Invert
Auto Power On	Off, On
Auto Power Off	Off, 5Min, 10Min, 15Min, 30Min, 60Min
Auto Keystone	Off, On
Language	English,	, Español, Français, Italiano,	, Deutsch,	, Polski, Português,	, Svenska, Indonesia, , Türkçe, Magyar,	, Bahasa Malaysia
Reset All	OK

Password	OK	Password	Off, On
		Change Password	xxxx

Cinema Mode	*3	Auto, Off
Video Signal	*5	Auto, NTSC, PAL, SECAM, 4.43NTSC, PAL-M, PAL-N, PAL-60
WXGA	*2	Off, Auto, 1280x768, 1280x768RB, 1280x800, 1360x768, 1366x768
Set Up	*1	Auto, Off, 3.75%, 7.50%
Image Capture		OK
Splash Screen		Original, User, Off
Back Color		Blue, Black, Image Original, Image User
AV Mute Mode		Black, Image Original, Image User
Closed Caption	*1	Off, CC1, CC2, CC3, CC4, T1, T2

Network Config

Projector Name Network Certification

Network Password

IP Config

Wireless Setting

xxxxxxxx..., SET

On, Off

OK

OK

OK

DHCP	On, Off
IP Address	0-255
Subnet Mask	0-255
Default Gateway	0-255
MAC Address	xx-xx-xx-xx-xx-xx
DHCP Function	Off, On
Start IP Address	0-255
End IP Address	0-255
IP Config Setup	OK
SSID	xxxxxxxx..., SET
Channel	Auto, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11
Encryption	SET , Off, WEP 128bit(ASCII), WEP 64bit(ASCII), WEP 128bit(HEX), WEP 64bit(HEX),
Wireless Setup	WPA-PSK(ASCII), WPA2-PSK(ASCII), WPA-PSK(HEX), WPA2-PSK(HEX)
	OK

AMX Device Discovery	Off , On
Network Initialization	OK
Network Restart	OK

Interactive Pen

Information

Interactive Mode

Dual Pen

Pair New Device

Lamp Time

Input

Resolution

H.Frequency

V.Frequency

Sync. Type *2

On, Off

On, Off

OK

*1: Not available with certain signals.

*2: Not available when the input signal is from the VIDEO or S-VIDEO terminal.

*3: Available only when the input signal is TV60, TV50, 480i, or 576i.

*4: The range that can be specified varies across input signals.

*5: Available only when the input signal is from the VIDEO or S-VIDEO terminal.

*6: Audio 1, Audio 2, Audio 3, and Mix cannot be selected when the input source is HDMI input.

*7: “” is not displayed and is not available in WD385U-EST.

*8: This function is not available in WD385U-EST.

EN-20