Sears 153.336332, 153.336701, 153.336801, 153.336432, 153.336431, 153.336901 Valve Operation

Page 20

r!ll,i

Temperature-Pressure Relief

Valve Operation

The temperature-pressure relief valve must be manually operated at least once a year.

I TEMPERATURE-PRESSURE

DRAIN LINE _"

WARNING

When checking the temperature-pressure relief valve operation, make sure that (1) no one is in front of or around the outlet of the temperature-pressure relief

valve dischargeline, and (2) that the water manually dis- charged will not causeany property damage becausethe water may be extremely hot.

if after manually operating the valve, it fails to complete- ly reset and continues to release water, immedlately closethe cold water inlet to the water heater, follow the

draining instructions,and replace the temperature-pres- sure relief valve with a new one.

Failure to install and maintain a new properly listed tem- perature-pressure relief valve will release the manufactur- er from any claim which might result from excessive tem- perature or pressure.

WARNING

If the temperature-pressurerelief valve on the appliance weeps or discharges periodically, this may be due to

thermal expansion. Your water heater may have a check valve installed in the water line or a water meter with a

checkvalve. Consultthe SearsService Center for further

information. Do not plug the temperature-pressure relief valve.

Draining

The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.

1.Turn the gas control knob to the "OFF" position.

2.CLOSEthe cold water inlet valve to the water heater.

3.OPEN a nearby hot water faucet and leave open to allow for draining.

4.Connect a hose to the drain valve and terminate to an adequate drain.

5.OPEN the water heater drain valve to allow for tank draining.

NOTE: If the water heater is going to be shut down and drained for an extended period, the drain valve

should be [eft open with hose connected allowing water to terminate to an adequate drain.

6.Close the drain valve.

7.Follow instructions in the "Filling The Water Heater" section.

8.Follow the lighting instructions in the "Lighting" section to restart the water heater.

Drain Valve Washer

Replacement

NOTE: For replacement, use a '%_x" '%4"x ½" thick washer available at your nearest hardware store. For ordering replacement washers,refer to the "Repair Parts"section.

t.Turn "OFF" gas supply to water heater.

2. Follow "Draining" instructions.

3.Turning counter clockwise, remove the hex cap below the screw handle.

4.Remove the washer and put the new one in place.

5.Screw the handle and cap assembly back into the drain

valve and retighten using a wrench. DO NOT OVER TIGHTEN.

6.Follow instructions in the "Filling The Water Heater" section.

7.Check for leaks.

8.Follow the lighting instructions in the "Lighting" section to restart the water heater.

HANDLE AND

CAP ASSEMBLY :WASHER

Service

If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out. Cal! the SearsService Center.

2O

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model Numbers For Your SafetySave this Manual for Future Reference Installation in Residential Areas Where Flammable J Area, as well as property damageDamage Water heater with draft hood installed must be properlyDeathseriousbodily Injuryor Propertydamage High Temperature Shut Start Up ConditionsThermal Expansion OperationalType GAS RateNatural Pipe Diameter JackettopWhen Sweat Soldering Your local Sears storeDhii Additional Tools NeededWater heater. This will avoid cutting NNI Facts to Consider About LocationAllair from Inside Buildings 1Figure 3Temperature-Pressure Relief Valve SwEatcOUPLznG =Vent Pipeinstallation Water beater with draft hood installed must be ConnectFilling the Water Heater Tion, explosion or asphyxiationGAS Piping with Flexibleconnector Applianceand itsindividualshutoffvalvemustbe disconIf thegas controlValveis subjectedto pressuresexceeding½ GAS Piping with ALL Black Iron Pipe to GAS ControlModel Rating Plate Installation ChecklistBefore Lighting the Pilot Check for Leaks Set the thermostatto lowest settingby turningthe Whatto Doif YousmellgasControlsystemand any gas controlwhichhas been underwater Not ForceIsa thermostat setting of approximately t 30F SMOKE/ODOR Thermal ExpansionStrange Sounds Smelly WaterHigh Temperature Shut Smelly Water contdNot Enough or no HOT Water SystemErty Damage Burner CleaningBurner Inspection Valve Operation Usethisguideto checka Leakingwater heater. Many Page SiR Sears Installation Policy

153.336331, 153.336432, 153.336701, 153.336631, 153.336332 specifications

Sears has undergone considerable evolution over the years, with a notable shift in its retail strategy and technological integration. The coordinates 153.336801, 153.336901, 153.336431, 153.336332, and 153.336631 reflect specific locations where Sears stores have played a significant role in local economies and communities. Each store carries its own unique features, but they are all part of a larger narrative about the company's direction and offerings.

One of the main features of Sears stores is their extensive range of products, which traditionally included appliances, apparel, tools, and home goods. Their commitment to providing quality merchandise is reflected in brand partnerships and exclusive products that are available only at Sears. The company has celebrated its long history of offering Kenmore appliances, Craftsman tools, and DieHard batteries, which have become trusted household names.

The implementation of technology has also been significant in transforming the shopping experience at Sears. The integration of online shopping capabilities has allowed customers to browse and purchase items conveniently through an e-commerce platform. This omnichannel approach enables users to research products online, find local store inventories, and even opt for in-store pickup, catering to today’s preference for flexibility.

In addition to basic retail functionalities, Sears has been at the forefront of utilizing mobile technologies for better customer engagement. Their mobile app allows shoppers to access exclusive deals, track rewards, and utilize digital coupons, enhancing the overall shopping experience. Sears has also embraced loyalty programs, giving returning customers benefits and additional savings opportunities, which helps foster brand loyalty.

Sears' commitment to sustainability and environmental awareness is another characteristic that sets it apart. Many of their appliances and products are designed with energy efficiency in mind, aligning with a growing consumer demand for eco-friendly options. Features like energy-saving modes in appliances reflect a trend toward responsible shopping.

Overall, the coordinates that refer to the locations of Sears stores encapsulate a legacy of convenience, versatility, and innovation in retail. As the company continues to adapt to changing markets, its focus on technology, sustainability, and quality remains central to its identity and appeal. Sears remains a staple in the retail landscape, offering both innovation and a sense of tradition for its loyal customers.
Top Page Image Contents