Sears 153.336701, 153.336801, 153.336432, 153.336431 Nni, Facts to Consider About Location

Facts to Consider About the

Location

You should carefully choose an indoor location for the new water heater, because the placement is a very impor- tant consideration for the safety of the occupants in the building and for the most economical use of the appli- ance. This water heater is not for use in mobile homes or outdoor installation.

Whether replacing an old water heater or putting the water heater in a new location, the following critical points must be observed.

t. The location selected should be indoors as close as practical to the gas vent or chimney to which the water heater vent iS going to be connected, and as centralized with the water piping system as possible. The water heater, as all water heaters, Will eventually leak. Do not install without adequate drainage provi- sions Where waterflow will cause damage.

CAUTION

The installation of the water beater must be accom-

plished in such a manner that if the tank or any connec- tions should leak, the flow of water will not cause dam-

age to the area adjoining the water heater, or to the lower floors of the structure. When such locations can-

not be avoided, a suitable drain pan should be installed under the water heater. Drain pans are available at your local Sears store. Such a ]_an s]lould be nogreater than 1½ inches deep, have a minimum length and-width of at least two inches greater than the water heater dimen-

sions and must be piped to an adequate drain. The pan must not restrict combustion air flow. Under no circum-

stances is the manufacturer or Sears to be held liable for

any water damageJ_connection with this water heater.

WARNING

INSTALLATION IN RESIDENTIAL AREAS WHERE

FLAMMABLE LIQUIDS (VAPORS) ARE LIKELY TO BE PRE-

SENT OR STORED (GARAGES, STORAGE AND UTILITY AREAS, ETC)" Flammable liquids (such as gasoline, solvents, propane (LP) or butane, etc.) or other substances (such as adhesives, etc.), all of which emit flammable vapors, may be improperly stored or used in such areas. The gas water

heater, pgot li ht or main burner can i nite such va.pors.The resulting flashback and fire can cause _eath or senous burns

to anyone in the area, as well as property damage.

tf installatlon in such areas is your only option, then the installation must be accomplished in a way that the pilot flame and maln burner flame are elevated from the floor at least 18 inches. While this may reduce the changes of

flammable vapors from a floor spill being ignited, gasoline and other flammable substances should never be stored or

used in the same room or area containing a gas water heater or other open flame or spark producing appliance. Also, the water heater must be located and/or protected so it is not subject to physical damage by a moving vehicle. NOTE: Flammable vapors maybe drawn by air currents from other areas of the structure to the appliance.

WARNING

Propellants of aerosol sprays and volatile compounds, (cleaners, chlorine based chemicals, refrigerants, etc.) in addition to being highly flammable in many cases, will also change to corrosive hydrochloric acid when

exposed to tee combustion products of the water heater. The results can be hazardous, and also cause product failure.

2. The Iocation selection must provide adequate clear-

ances for servicing and proper operation of the water heater.

WARNING

This water heater must not be installed directly on car- peting. Carpeting must be protected by a metal or

woodpanel beneath the appliance extending beyond

the fullwidth and depth of-tTae appliance by at least 3 inches (76.2mm) in any direction, or if the appliance is installed in an alcove or closet, the entire floor must be

covered by the panel. Failure to heed this warning may result in a fire hazard.

WARNING

Minimum clearances between the water heater and combustible construction are 1" at the sides and rear, 4" at

the front, and 6" from the vent pipe. Clearance from the top of the _acket is either 12" or 18". Refer to the label on

the water heater located adjacent to the gas control valve for all clearances.

	m
]2" MAX		_	ivIIN.
	VENTU.A_ON
	AIR			4"
	OPENINGS		I'"MIN,
	NNI		TOP VIEW
			OF (_L,OSET	i" MN.
		m	WITHOUT DOOR	TOP VIEW
				OF CLOSET
6"	N]N_L.	t2.._"M/_X		WITH DOOR
	VIEW
	OF DOOR
I	Figure 1 j		AIR DUCT

WARNING

A gas water heater cannot operate properly without the correct amount of air for combustion. Do not install in a

confined area such as a closet, unless you provide air as shown in Figures 1-5. Never obstruct the flow of ventila- tion air. If you have any doubts or questions at all, call your gas company or Sears Service Center. Failure to provide the proper amount of combustion air can result in a fire or exposion and can cause DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE.

if this water heater will be used in beauty shops, barber shops, cleaning establishments or self-service laundries

with dry cleaning equipment, it is imperative that the water heater or water heaters be installed so that com-

bustion and ventilation air be taken from outside these

areas. Refer to the "Locating the New Water Heater sec- tion" of this manual and also the latest edition of the

National Fuel Gas Code, ANSI Z223.1, also referred to as NFPA 54 for specifics provided concerning air required.

8