Troubleshooting
TROUBLE |
|
| PROBABLE CAUSE | |
L/nit will | not | run | • Selected humidity levet has | |
and Fill Light is not |
| been established | ||
illuminated. |
| • No power | ||
Unit will | not | shut | • | Float is not flee |
off |
|
| • | Float retainer positioned in top |
|
|
|
| slot at back of cabinet |
Unitwill notdry out | • This is normal | |||
completely |
|
|
| |
Unit is not |
|
|
| Dirty filters |
emptying | during |
|
| |
lee |
|
|
|
|
REMEDY
I- Raise humidistatsetting if desired
•Check 120 volt source for power
•Free float from obstruction
•Slide float retainer down to lowest position in slot at back of cabinet. Refer to "Manual Dryout" section on page 7.
•A small amount of water will
remain in cabinet after fill light comes on.
•Change to fresh new filters
Nater runs out of | Water splashing during filling. | • | Deflect fill water off the splash |
ear of unit | Too much water added |
| guard |
|
| • | Do not overfillpast "Full" labels in |
|
|
| cabinet |
CAUTION: Use only
Use of other water treatment products may damage the filter elements.
Under no circumstances should you use water treatment products designed for r3oto belt or Ultrasonic humidifiers,
13