Operating Humidifier Controls
The operating controls of your Kenmore Quiet Comfort Whole House humidifier are
located on the top center of the humidifier. The controls are found under the smoked
control cover, located between the air cir- culating fans.
Lift the control cover by placing your finger in the round cutout and lifting. The cover will stay open. Now you can clearly see the control area. Familiarize yourself with the controls and reference the diagram of the
control area for the correct naming used in this manual.
o
MIN •
3
To Operate the Controls
Humidity Control: b_
Adjust the amount of humidity depending on your needs. The humidifier will turn on and off as required to maintain level of humidity selected. A medium setting (half way between MIN and MAX) is recom- mended, but there are times when a low or high amount of humidity may be preferred.
For constant operation of humidifier, MAX allows for the maximum amount of humidi-
ty to be evaporated into the air continuous-
IMPORTANT: Water damage may result if condensation starts to form on windows or
walls. Humidity Control setting should be
lowered until condensation no longer forms.
Speed Control _)
Your Kenmore humidifier has a three speed rotary fan control. The higher the air flow speed, the more water is evaporated and released into the air. Low speed (1) is the quietest and is provided for conditions
that may not require as high an evapora- tion rate.
Fill Light
When the unit has a small amount of water left in it, the fill light will come on and the unit will automatically shut off.
OFF
FILL
O
Manual Dryout
At the end of the humidification season or if you do not plan to run the humidifier for one week or more, you can override the automatic shutoff function to completely dry the humidifier cabinet out.
To do this, simply slide the float retainer located at the back of the humidifier cabi- net to the top position of the slot it is locat- ed in. This will hold the float in an upward position and the fans will run until you turn the power off.
NOTE: Be sure to position float retainer to the normal operating mode (lowest posi- tion in slot) for humidifier operation.
Below is a diagram of the slot the float retainer is located in at the back of the cab-
inet.
,<_ OP POSITION IS FOR
MANUAL DRYOUT
,<_
7