Niles Audio SI-2100, SI-250 Use audio patch cables with RCA, RCA plugs into the amplifier’s jacks

2 Channel, Bridgable Power Amplifiers

Installation

Line Level Audio Input

Caution! The amplifier must be off whenever you make changes to the input connections.

STEP		DESCRIPTION
1.	Label all of the interconnecting cables	Use audio patch cables with RCA
	for the sources they connect to.	phono plugs attached to the ends.
		Connect outputs from your sources
2.	Connect the sources by inserting the	to inputs on the amplifier. Never
		connect a source or preamplifier’s
	RCA plugs into the amplifier’s jacks.	input (e.g., record inputs) to
		the inputs of your Niles System
		Integration Amplifier®.

Cascade Audio Outputs

The “Cascade Audio Outputs” enable you to connect another amplifier to your preamplifier output. The connectors are gold-plated RCA phono jacks. Connect them to another amplifier’s inputs with a standard audio patch cable. The outputs are not buffered; if you wish to daisy-chain more than 5 Niles System Integration Amplifier® amplifiers you will need a Niles AVDA-3 buffered distribution amplifier. A single AVDA-3 will allow you to daisy-chain 5 amplifiers from each of its three outputs, allowing for as many as 30 Niles System Integration Amplifier® models to be fed from the same master preamplifier. If your preamp has a vacuum tube output stage, you must use a Niles AVDA-3 to drive more than a single Niles System Integration Amplifier®.

NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 1-760-710-0992 15