Hunter Fan 42711-01 operation manual Icons and FEATURES

Page 41

ICONS AND FEATURES, cont.

3.Span setting mode – allows you to adjust the system ON/OFF cycle rate. The default setting is 2 (the system cycles ON or OFF when the temperature is within 1o F (0.5o C) above and below the set temperature.) The span setting can be adjusted if your system is cycling too fast or too slowly.

Press and hold both the Up and Down buttons until the word SPAN appears. Use the Up or Down button to adjust the span setting.

(Up will increase your cycle time by allowing the system to run longer; Down will decrease your cycle time by causing the system to run for a shorter length of time.)

Span settings remain the same for HEAT and COOL system settings. When batteries are installed, or the unit is RESET, the span cycle will revert to 2.

41

Page 40 Page 42
Image 41
Page 40 Page 42
Contents
Set & $ave Page Table of Contents Set & Save Important information Tools Page Page Locate, but do not disconnect the wires RC / VC Uninstalling the existing unit, Page Installing the Wall Plate Page Installing the thermostat, RCRHY/0W/BY1 Connecting the Wires Thermostat Cover Attaching the Thermostat Tab Installing the thermostat, Reset Default setting of the thermostat is Fahrenheit Fo Day/time SETTINGS, Heat Methods of operation Heat Manual Operation System Manual OPERATION, Default Programs Chart Default Programs Program Press Program to enter Program mode. Creating Custom ProgramsHeat Cool Methods of operation, Filter Icons and Features Reset Icons and FEATURES, Stage Icons and FEATURES, Hold /return Icons and FEATURES, Page Icons and FEATURES, Program Range Wiring Wiring, Wiring, Troubleshooting Display will come on, but it will not stay illuminated LCD screen permanently reads HI, LO, or ERR Is there help on the web? Can’t I just call someone?
Top Page Image Contents