Lux Products TX9000TS Advanced Features, Filter Usage Monitor, Swing Setting

•Set the mode switch to HEAT to program the unit for controlling your heater. Set the mode switch to COOL to program the unit for controlling your air conditioner.

•Touch MENU.

•Use SCROLL to advance to SET/REVIEW HEAT PROGRAMS or SET/REVIEW COOL PROGRAMS.

•Touch YES to begin scrolling through the HEAT or COOL settings.

•Use the UP/DOWN ARROW to change the flashing start time for MON MORN. One period ends at the start time of the next period. The beginning of a period may not be any closer to the beginning of the next period than one 15 minute increment.

•Touch YES to accept the displayed start time and advance to program its set temperature.

•Use UP/DOWN ARROW to change the flashing temperature setting for MON MORN.

•Touch YES to accept the displayed temperature and advance to Set MON DAY start time.

•Use the UP/DOWN ARROW to change the flashing start time for MON DAY.

•Touch YES to accept the displayed value and advance to program temperature.

•Use UP/DOWN ARROW to change the flashing temperature setting for MON DAY.

•Touch YES to accept the displayed temperature and advance to Set MON EVE start time.

•Use the UP/DOWN ARROW to change the flashing start time for MON EVE.

•Touch YES to accept the displayed value and advance to program temperature.

•Use UP/DOWN ARROW to change the flashing temperature setting for MON EVE.

•Touch YES to accept the displayed temperature and advance to Set MON NITE start time.

•Use the UP/DOWN ARROW to change the flashing start time for MON NITE.

•Touch YES to accept the displayed value and advance to program temperature.

•Use UP/DOWN ARROW to change the flashing temperature setting for MON NITE.

•Touch YES to accept the displayed temperature and advance to Set TUE MORN start time.

•Continue programming for each day of the week.

•Touch EXIT to return to main screen.

TIP: Pressing Day, Time or Temperature while programming will shift focus to that setting, allowing it to be edited in the order most

convenient for you.

5.2.1. COPY

COPY will copy the previous days programs into the current day and advance the thermostat to the beginning of next day.

6. ADVANCED FEATURES

6.1. FILTER USAGE MONITOR

The FILTER MONITOR is used to help determine when your filter should be changed. It counts the hours of HEAT and COOL since it was last reset When the monitor limit is reached the CHANGE FILTER indicator will become visible. The default value of 720hrs is normally used for a 90 day filter. Other values are given in the following table.

To Reset Filter Counter And/Or Change The Counter Limit

•At the main menu touch MENU.

•SCROLL to FILTER USAGE.

•Touch YES. Filter Usage Count will appear.

•Touch NEXT. RESET will show.

•Touch YES to reset the counter and advance to the filter limit menu, or touch NEXT to advance to the filter monitor menu without resetting the counter. Limit Hours will be flashing.

•Use UP/DOWN arrows to change limit. Set the filter limit to "0" to disable the Filter Usage Monitor.

•Touch YES to accept new count value and return to the filter counter menu. If a new limit is set, the filter counter will be reset automatically.

•Touch EXIT to return to main menu.

6.2. SWING SETTING

A thermostat works by turning your heating or cooling system on and off whenever the room temperature varies a certain number of degrees from the set-point temperature. This variation is the "swing." Your system should cycle on about 3 to 6 times per hour. A smaller swing number increases the number of cycles, so room temperature is more constant. A larger swing number decreases the number of cycles, saving energy in most cases. To change the SWING value from the main menu:

•Touch MENU.

•SCROLL to SWING VALUE.

•Touch YES. Adjust Swing Value will appear.