Carrier PTACSTAT-NP-HP Setting the temperatures for heating and cooling, Using the fan

Page 20

4Thermostat mode is Cool

5Thermostat mode is Heat

6Thermostat mode is emergency heat

7Fahrenheit

8Celsius

9Battery strength indicator

10Aux Heat is On

11Compressor is On (if flashing, it is waiting to come on)

12Current setpoint (if configured to display room temp)

Setting the temperatures for heating and cooling

Your thermostat is installed with the heating set at 68_F and the cooling set at 72_F. You can use these or change them so your room is as warm or as cool as you would like it to be. These steps will hold the temperature where you set it.

1.To change the heating temperature, press the mode button on the left until the screen says heat.

2.Press the up or down button located on the right side of the display until you reach the desired temperature.

3.To change the cooling temperature, press the mode button on the left until the screen says cool.

4.Press the up or down button located on the right side of the display until you reach the desired temperature.

Using the fan

When the fan is on, it helps distribute air for a more even temperature in all spaces. You can set the thermostat so the fan runs continuously (on) or only

20

Image 20

Contents Installation Instructions Operating Manual Page Table of Contents Safety ConsiderationsInstallation Considerations PowerIntroduction ModelsInstallation BatteriesMounting to a horizontal junction box Thermostat LocationInstall Thermostat Electrical Operation HazardEnvironmental Hazard Secure Wires to Terminal Strip Terminal Designations Attach Comfort Series Programmable Thermostat Set Thermostat Configuration Configuration Options SummaryOption 01 Equipment type Configuration Options SelectionTo Enter the Advanced Configuration Mode Option 03 Fahrenheit/Centigrade Option 04 Not used on a Ptac systemOption 07 Not used on a Ptac system Option 10 Reversing valve HP onlyOption 16 Maximum Cycles Per Hour Option 13 Room Air Temperature OffsetOption 11 Minimum Deadband Between Heating And Cooling Option 18 Backlight Configuration Option 17 Minimum Time Between Equipment Stages HP onlyOption 26 Minimum Cooling Setpoint Option 27 Maximum Heating SetpointOption 99 Reset to Factory Defaults Check Thermostat OperationChecklist Operating the Thermostat Button IdentificationOn-Screen Indicators Display backlightingSetting the temperatures for heating and cooling Using the fanTurn the unit off Installing or replacing the batteriesUsing emergency heat heat pump units only Page Battery icon is displayed There is a power outageMy Thermostat does not show room temperature What ifYou get a system error message There are icons flashing on the thermostat displayThermostat Limited Warranty Limited Warranty for Thermostat Warranty ConditionsThis Warranty does not Cover Page Outputs Wiring Diagrams C Thermostat Typical InstallationThermostat Configuration Record Catalog No PTACSTAT---NP---01SI