Niles Audio RS 5s manual Installation Considerations, Choosing the Speaker Cable

Page 8

INSTALLATION CONSIDERATIONS

30 Feet (9.1 mm)

8Feet

(2.4 mm)

D=16 Feet (4.9 mm)

16Feet

(4.9 mm)

8Feet

(2.4 mm)

Figure 3 Mono Coverage 4 speakers

Figure 3 shows the difference in coverage area using the spacing rules for mono signals. Using the same four speakers as we did in Figure 1, we can increase our coverage area from 560 square feet (52 sq. meters) to 960 square feet (88.3 sq. meters), simply by using a mono source.

The trade off in sound quality between mono sources and stereo sources is sonic imaging. If you are concerned with keeping the instruments and vocals sonically separated, then stereo setup must be used.

When choosing the location for the loudspeaker, take into consideration the slope of the land in the area the speakers are going to be placed. The flatter and more level the area, the better. The woofer should be straight up and down or tilted forward a bit to assist in drawing water away from it. Never chose a place where an automatic sprinkler will be aimed on or near the loudspeaker. While the loudspeaker is weatherproof, continuous streaming water will shorten the product’s life and void the warranty.

Choosing the Speaker Cable

In order to choose the proper speaker cable, please follow these steps:

•Unless you are using a Niles’ WVC100 or WMVC100 series weatherproof impedance matching volume controls or equivalent, only two (2) RS5 loudspeakers can be safely attached to a typical amplifier channel, if that amplifier is rated to drive 4 ohms. You can do this by running wires from each loudspeaker to the amplifier or you can connect one loudspeaker to another. Make sure this is taken into account when calculating cable length and number of amplifier channels needed. If you are unsure about these calculations, consult an audio/video installer.

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents RS5 Table of Contents Introduction Features & Benefits Connection Cable with Water Resistant Wire Nuts Precision CrossoverConeForward Design Rigid Acoustically Inert Cabinet ConstructionSelecting the number and location for your speakers Installation ConsiderationsTools and Materials Required Stereo Coverage 6 speakers Installation Considerations Choosing the Speaker CableIncorporating a Volume Control 60 ft 18 m 100 ft 30 m 160 ft 50 mTwo Zone Volume Control Wiring Recommended Amplifier PowerRun the speaker cable InstallationConnecting the loudspeaker Speaker wire preparation Speaker PhaseVerify System Operation and Loudspeaker Coverage Installing the Security Bracket and Cable Security Cable in EyeletSecurity Stake Driven into Ground Upgraded Security Attachment Method Optional To install an upgraded security systemFinal Adjustments Operation Listening at Higher VolumesCleaning Specifications Nominal ImpedanceNiles Audio Corporation

RS 5s specifications

The Niles Audio RS 5s are a remarkable addition to any enthusiast’s audio setup, offering a blend of advanced technology, thoughtful design, and superior sound quality. These speakers are engineered to deliver an immersive audio experience, underpinned by a host of features that cater to both casual listeners and audiophiles alike.

One of the standout features of the RS 5s is their dynamic range. They incorporate a 5.25-inch woofer that delivers deep, rich bass, allowing for an expanded low-frequency response that enhances music and movie soundtracks alike. This woofer works in conjunction with a 1-inch silk dome tweeter, which ensures that high frequencies are reproduced with clarity and precision, resulting in a balanced sound profile that captures the nuances of the audio.

The construction of the RS 5s also contributes significantly to their performance. Designed with MDF cabinets, these speakers minimize resonance and distortion, promoting a cleaner sound output. The cabinets are finished with an attractive veneer that not only enhances aesthetic appeal but also reinforces durability. Additionally, the speakers come equipped with a rear-firing bass port that aids in delivering increased bass extension and responsiveness, allowing for greater flexibility in placement within a room.

Another noteworthy aspect of the Niles Audio RS 5s is their versatility. They are designed for both indoor and outdoor use, making them an excellent choice for various settings, from home theaters to backyard gatherings. The weather-resistant design ensures longevity when exposed to outdoor conditions, which is crucial for users who enjoy entertaining outside.

In terms of connectivity, the RS 5s support a range of integration options, allowing them to seamlessly connect with various audio systems, including multi-room setups. This compatibility makes them a smart choice for those looking to create a cohesive audio environment throughout their living spaces.

Overall, the Niles Audio RS 5s stand out due to their impressive sound quality, robust build, and innovative features that cater to a wide array of audio applications. Whether you're enjoying your favorite music or watching an action-packed movie, these speakers promise an engaging auditory experience that elevates your listening pleasure to new heights.
Top Page Image Contents