Figure 4
Figure 5
5.Mount push button. Use either screws or double sided tape to mount push button.
•Screw Mounting: To mount with screws, re- move back of case by pushing in tab on bottom with a small screwdriver (see Figure 1). Note: Remove material in screw holes (if needed) before mounting with screws. Attach back of case to door jamb or wall (see Figure 4). Snap front of push button on.
•Tape Mounting: When attaching push button using double sided tape, make sure the surface of the door jamb or wall is clean.
6.Mount chime. Determine mounting location.
•Drill 7/32" diameter pilot hole for wall anchor.
•Mount keyhole screw to wall leaving about 1/8" (3 mm) of the screw threads exposed.
•Replace cover onto battery compartment.
•Using keyhole on back of chime base, hang base on screw (see Figure 5).
|