Niles Audio manual Connecting the SWA-500M, Calibrating the SWA-500M

Page 17

CONNECTING THE SWA-500M

Connect the SWA-500M according to your application (see APPLICATIONS on page 11). Use high- quality RCA cables for all line-level connections (see CONTROLS AND CONNECTORS on page 7).

For applications with loudspeaker-level connections, perform the following steps:

1.At each SWA-500M loudspeaker-level connection, separate the loudspeaker wire so that at least 2” of each conductor are free. Strip away 1/4 inch of insulation from each loudspeaker wire. Using correct polarity, connect the appropriate conductor to each five-way binding post.

NOTE: OBSERVE CORRECT POLARITY: POSITIVE (+) GOES TO THE RED POST AND NEGATIVE (–) TO THE BLACK POST. IF YOU ARE UNSURE OF WIRE POLARITY, SEE THE SECTION, CHECKING PHASE ON SATELLITE LOUDSPEAKERS, ON PAGE 17.

2.Connect the other end of the loudspeaker wires to the home theater receiver/amplifier and satellite loudspeakers in the same way.

3.Turn on the home theater receiver and calibrate all loudspeakers in the system according to the receiver (or surround processor) manufacturer’s instructions.

CALIBRATING THE SWA-500M

After installing the amplifier and making all the connections, set up the SWA-500M by performing the following steps. Performing these steps will maximize the SWA-500M’s performance (see CONTROLS AND CONNECTORS page 7 for information on control operation).

1.On the rear panel, set the (Master) POWER switch to ON. On the front panel, set the POWER switch to ON. Depending on your application, set the rear-mounted (Auto) POWER switch to ALWAYS ON or MUSIC/VOLTAGE SENSE.

2.On the front panel, set the following controls (and switches) to their initial positions:

HIGH PASS FREQUENCY control = 120 Hz (or value recommended by satellite loudspeaker manufacturer)

PHASE control = 0º

HIGH PASS FREQUENCY control = 140 Hz (or value recommended by satellite loudspeaker manufacturer)

HIGH PASS ON/OFF switch = ON

LEVEL SETUP switch = MUSIC

MUSIC LEVEL control = 5

MOVIE LEVEL control = 5

NILES AUDIO CORPORATION – 1-800-BUY-HIFI

 

15

 

Image 17
Contents SWA-500M Congratulations Table of ContentsIntroduction Niles SWA-500M high-power subwoofer amplifierImportant Safety Instructions Maximum Subwoofer Performance Flexible Installation & Multiple Bass CapabilitySmooth and Accurate Bass Efficient Amplification TechnologyInstallation Considerations SWA-500M PlacementCleaning Rack Mounting the SWA-500M Connection to AUDIO/VIDEO Sources Loudspeaker WireConnecting the SWA-500M Controls and Connectors Running Wires in Walls or CeilingsIs indicated by the green LED on the front panel Signal Connectors and Power ControlsNiles Audio Corporation 1-800-BUY-HIFI Main power switch Applications SWA-500M in a Typical Home Theater InstallationSWA-500M and LINE-LEVEL Connection Connecting satellite loudspeakers Trigger connection Calibrating the SWA-500M Connecting the SWA-500MPage Checking Phase on the Satellite Loudspeakers Problem No sound Troubleshooting GuideSpecifications Limited Warranty Yes Warranty Registration CardL e s a u d i o C o r p o r a t i o n