Assa 32, Model 34 manual Magnet Dimensions

Rev. A.5, 8/03 Page- 6

sheet rock do not constitute a secure mounting substrate). Note that when the roll pin bushings are used, they protrude through the Z bracket and interfere with the Z bracket cover. If a Senstat lock is being employed, the roll pin bushings must be used to provide insulation. They should be cut with a hacksaw to function in the bracket. If the lock is not Senstat, omit use of the roll pin bushings and drill 3/8" (9.5mm) diameter holes for the roll pins instead of 1/2" (12.7mm). Read sections 2.3, 2.3.1, and 2.3.2 for additional general information on mounting.

FIG. 6: F MAGNET DIMENSIONS

Blind Nut
PN# BN-250 or
PN# BN-6MM (Metric)
(Pack of 24 with tool)	Model 62F

If "G" option is furnished, the wire cable emerges from a 3/4" male; 1/2" female conduit fitting on the end of the magnet (62 and 82 models only)

)

4

2

r

f

o

e

k

h

c

s

a

a

P

W

(

1

d

-

l

W

o

G

F

N#

P

Model 32F

			Length	Width	Depth
		32	8"	1.88	1.5
1/4-20 x 2 1/2" Cap Screw		(mm)	203	47.8	38.1
PN# SCS-25 or		62	8"	2.9	1.75
6mm-1mm x 60mm	Tamper Cap	(mm)	203	73.7	44.5
PN# SCS-60mm (Metric)		82	12"	2.9	1.75
Pack of four screws	PN# FC-1 (Pack of 24)	(mm)	305	73.7	44.5