Rev. A.3, 5/00 | Page- 11 |
A back plate or Securitron's Z bracket must also typically be provided for the strike plate. The strike plate cannot be directly welded to the gate as it will not be able to flex and self align. It must be screwed onto a surface with the washer stack used to provide flexibility. Note that if Securitron's Z bracket is used, it typically bolts to the gate rather than is welded as it is aluminum. Read sections 2.3, 2.3.1, and 2.3.2 for additional general information on mounting.
FIG. 11: MOUNTING TECHNIQUES FOR GATES
SINGLE SWING GATE
CONDUIT FITTING MAY EXIT TOP OR BOTTOM
GF MAGNET
Z BRACKET BOLTED TO SWING ARM
STRIKE
DOUBLE SWING GATE
Z BRACKET BOLTED TO SWING ARM INTERFERENCE PIECE MUST 
BE ADDED TO Z BRACKET
MOTORIZED OPENING MUST BE COORDINATED
DIRECTION OF OPENING
SLIDING GATE
CONDUIT FITTING | GATE | EXTENDED ROLL PIN | |
EDGES | |||
| |||
|
| ||
|
| LOCK NUTS | |
ANGLE BRACKET |
| ANGLE BRACKET | |
|
| SPRING |
GF MAGNET | EXTENDED ROLL PIN | |
STRIKE | ||
|