Operation
Remote
Control
Operations
The controls will look like the following.
Signal transmitter
5 |
|
| 1 |
6 |
|
|
|
|
|
| 3 |
4 |
|
|
|
2 |
| CANCEL | 10 |
|
| ||
|
| 9 | |
7 | OFF | SET | |
ON | 12 | ||
11 |
| AUTO CLEAN | |
8 |
|
| 17 |
13 |
|
| 18 |
|
| 14 | |
|
|
| |
15 |
|
| 16 |
Operation Mode
Cooling Operation
Auto Operation or Auto Changeover 
Healthy Dehumidification Operation
Heating Operation
• Cooling Model(
), Heat Pump Model( 
)
1. START/STOP BUTTON
Operation starts when this button is pressed and stops when the button is pressed again.
2. OPERATION MODE SELECTION BUTTON Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.
5. JET COOL
Used to start or stop the speed cooling.(speed cooling operates super high fan speed in cooling mode.)
6. CHAOS SWING BUTTON
Used to stop or start louver movement and set the desired up/down airflow direction.
7.ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation. (See page 22)
8.TIME SETTING BUTTONS
Used to adjust the time. (See page 22)
9.TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained and to cancel the Timer operation. (See page 22)
10.SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation. (See page 22)
11.AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating. (See page 23)
12.ROOM TEMPERATURE CHECKING BUTTON Used to check the room temperature.
13.NEO PLASMA(OPTIONAL)
Used to start or stop the
14.HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON (OPTIONAL)
Used to set the desired horizontal airflow direction.
15.RESET BUTTON
Used prior to resetting time.
16.2nd F Button
Used prior to using modes printed in blue at the bottom of buttons. (See page 21)
17.AUTO CLEAN (OPTIONAL) Used to set Auto Clean mode.
18.˚C TO ˚F SWITCHING BUTTON
Used to switch temperature reading from Centigrade to Fahrenheit.