Shark EP602F Operating Instructions Mesures DE Précaution, Important Make sure that ALL filters

Fig. 15

Fig. A

Wash once a month or when suction appears reduced

Warning: Allow 24 hours for drying before replacing in unit.

OPERATING INSTRUCTIONS

MESURES DE PRÉCAUTION

PLEASE NOTE: The white pleated filter material in the HEPA Filter will discolor over time -This is NORMAL and will NOT affect the performance of the filter. If the HEPA Filter

is properly "Tap Cleaned” after each use and suction does not return to 100%, then we suggest that the HEPA filter be “Tap Cleaned” vigorously until no more dust

Changing & Cleaning the Pre- Motor Filter

The pre-motor filter is a washable filter but should be replaced every three (3) months.

• Remove the dust cup container, the

Non-Woven Pre- Filter and the HEPA

filter to remove the pre-motor filter.

(Fig 14)

• Rinse the pre-motor filter in lukewarm

water and air dry the filter completely

for 24 hours. Do not use a washing

machine to rinse the filter.

Do not use a hair dryer to dry it. Air

dry only. Never operate the vacuum

without the pre-motor filter in place.

Important: Si l’orifice de succion ou le boyau de l’aspirateur est BLOQUÉ, arrêtez l’aspirateur et retirez l’obstruction avant de l’utiliser de nouveau.

1. Ne pas utiliser l’aspirateur près des	4. Pour débrancher la fiche de la prise
chaufferettes, radiateurs ou mégots	murale, tirez sur la fiche plutôt que
de cigarette.	sur le cordon.

can be removed, then rinsed

under the faucet and allowed to dry for 24 hours before refitting into the vacuum. (Fig. A) This should be done once a month or when suction appears to be reduced .

CAUTION: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.

WARNING: Always empty the dust cup container and clean the HEPA filter, Non-Woven Pre-Filter and Debris Screen before each use and during prolonged usage.

Never over fill the dust cup container - remove dirt and clean the HEPA filter, non-woven pre-filter and debris screen when dirt in dust cup is at or below the "MAX" level during prolonged usage or risk motor damage.

If you wash the Hepa filter or the non-woven pre-filter, make sure that they have completely air dried before inserting back in the vacuum.

Please Note: The HEPA Filter is washable. It should, however, be replaced every three (3) to six (6) months to ensure peak performance of your vacuum.

The non-woven pre-filter, pre-motor and post motor filters are washable. They should however be replaced every three (3) months to ensure peak performance of your vacuum.

Important: Make sure that ALL filters

• When the filter is dry, replace into the

unit and replace the HEPA filter and

dust cup container.

• A severely soiled or clogged filter

should be thoroughly washed with

fresh tepid water. A mild detergent

can be used if required.

Pre-Motor

Filter

Fig. 14

Changing & Cleaning the Post Motor Filter

The post motor filter is a washable filter but should be replaced every three (3) months.

•Remove the filter cover from the front of the unit and remove the filter. (Fig. 15)

•Rinse the post motor filter in lukewarm water and air dry the filter completely for 24 hours. Do not use a washing machine to rinse the filter. Do not use a hair dryer to dry it. Air dry only. Never operate the vacuum without the post motor filter in place.

•When the filter is dry, replace into the filter cover

and replace the filter cover to the unit.

• A severely soiled or clogged filter should be thoroughly

washed with fresh tepid water. A mild

2.Avant d’insérer la fiche dans une prise murale, assurez-vous que vos mains sont bien sèches.

3.Avant de commencer le nettoyage, assurez-vous d’enlever tout objet de grande taille ou pointu risquant d’endommager l’écran à débris de la coupelle.

5.Évitez d’utiliser l’aspirateur pour aspirer toute matière fumante ou brûlante comme des cigarettes, allumettes ou cendres chaudes.

6.Ne pas utiliser l’aspirateur sans que TOUS les filtres soit en place.

have completely air dried before re- installing back in the vacuum.

8

detergent can be used if required.

25