Shark MV3010 manual Vacuum Mode Storage, Checking for Blockages, Cleaning the Vacuum Nozzle

Page 11

Occasionally the vacuum may become blocked by a build up of debris and the Blockage Indicator light will illuminate. It is important to locate where the blockage is and carefully remove it without causing damage to yourself, the unit or anything else. Perform the following steps to try to find the blockage.

Beware of sharp objects when clearing blockages.

Damages caused while clearing or attempting to clear blockages are not covered under your product’s limited warranty.

Replace parts securely before using again.

Blockages may cause your vacuum to overheat and shut down. If so, clear the blockages, then follow the instructions for Resetting the Motor Thermostat.

Air Intake

Fig. 21

Fig. 20

CHECKING FOR BLOCKAGES

Dust Cup Air Duct:

1Remove Dust Cup Assembly and empty Dust Cup if necessary.

2Check Air Duct behind Dust Cup for clogs; clear before replacing Dust Cup Assembly. (Fig. 20)

CLEANING THE VACUUM NOZZLE:

The rotating brush in the vacuum nozzle must be free of debris for effective cleaning and maximum suction.

1Disconnect the vacuum nozzle and turn it over to inspect the bottom. If a build-up of debris is wound around the rotating brush, remove by carefully cutting with scissors. Avoid damaging or cutting the bristles. (Fig. 21)

MV3010_40_ENG_IB_120703_1.indd 7

Vacuum Mode: Storage

Fig. 22

Fig. 23

1Tilt the cleaning unit back into upright position.

2Tap the foot pedal until the unit returns to standby mode. The carpet light (on the left hand side of the nozzle) should be blinking blue. (Fig. 22)

3Unplug the unit.

4Wrap cord around cord holders and secure plug. Store cleaning unit in an upright position. (Fig. 23)

TO RESET THE MOTOR THERMOSTAT:

1Step on the foot pedal until it goes to standby mode.

2Unplug the vacuum.

3Empty the dust cup and clean filters.

4Check for blockages in hose, accessories and inlet openings.

5Allow the unit to cool for a minimum of 45 minutes.

Note: If vacuum still does not start, contact Customer Service

at: 1-800-798-7398.

www.sharkclean.com

7

12-07-03 9:16 AM

Page 10 Page 12
Image 11
Page 10 Page 12
Contents MV3010 Use only as described in this manual Important Safety InstructionsPolarized Plug Do not run the cleaning unit over large- sized objectsAttempt to Defeat This Safety Feature MV3010 Technical SpecificationsSteam Technology This Book Covers Model NumberContents Getting Started Vacuum ModeAttaching the Vacuum Nozzle Vacuum Mode AssemblyAssembly To return to standby mode, step on the pedal once more Vacuum ModeUsing Vacuum Mode Using the AccessoriesEmptying the Dust Screen Never OVER-FILL the Dust CUPEmptying the Dust CUP Remove the two foam filters from the unit Component Maintenance ScheduleTo Clean the PRE-MOTOR Filters To Clean the POST-MOTOR Hepa FilterChecking for Blockages Vacuum Mode StorageCleaning the Vacuum Nozzle To Reset the Motor ThermostatFilling the Water Tank Steam Mode AssemblyChanging to Steam Mode Assembly Steam ModeUsing Steam Mode Steam ModeTile Messes and stains Laminate Light cleaning and dustingMarble Remove spots and smaller messes Tile Stone Sanitize floorsStorage Steam Mode StorageTilt the cleaning unit back to the upright position Care of Your MULTI-PURPOSE Cleaning PADVac-OR-Steamwill not Troubleshooting GuideFoam & Hepa Filters XFF3010 Multi-purpose Steam Pad Ordering PartsPart Toll Free Product Registration EURO-PRO Three 3 Years Limited WarrantyCan

MV3010 specifications

The Shark MV3010 is a versatile and innovative cleaning system that redefines home cleaning efficiency. Combining advanced technologies with user-friendly design, this vacuum cleaner is ideal for tackling a wide range of surfaces, from carpets to hard floors.

One of the standout features of the Shark MV3010 is its powerful suction. Equipped with a high-efficiency motor, it effortlessly lifts dirt and debris, ensuring a thorough clean every time. This model also incorporates an advanced anti-hair wrap technology, specifically designed to prevent hair from tangling around the brush roll. This is particularly beneficial for pet owners, as it significantly reduces maintenance time and enhances the overall cleaning experience.

Another key characteristic of the MV3010 is its lightweight and ergonomic design. Weighing only a few pounds, this vacuum cleaner is easy to maneuver around furniture and up and down stairs. The swivel steering allows for effortless navigation, making it suitable for various home environments. In addition, the MV3010 features a detachable handheld unit that provides added versatility for above-floor cleaning. This makes it perfect for cleaning upholstery, stairs, and even vehicles.

The Shark MV3010 also comes equipped with a washable foam filter, which helps to capture allergens and fine dust particles, promoting a healthier home environment. The easy-to-access dust cup is another thoughtful addition; it allows for quick emptying and cleaning, minimizing contact with dirt and debris. The vacuum's large capacity dust cup means fewer trips to the trash can, making cleaning more efficient.

For added convenience, the MV3010 includes a variety of attachments, such as a crevice tool and upholstery tool, allowing users to customize their cleaning approach based on their specific needs. The vacuum is designed for easy storage, with its compact size enabling it to fit into tight spaces.

In conclusion, the Shark MV3010 stands out as a top-performing vacuum cleaner with its powerful suction, advanced hair management technology, lightweight design, and versatile capabilities. Whether you are a pet owner, have children, or simply want an efficient cleaning solution, the MV3010 offers everything you need for a cleaner, healthier home.
Top Page Image Contents