Shark NV350Q manual Maintenance, Reassemble all parts securely before operating vacuum

Maintenance

To reduce the risk of electric shock, unplug the unit before performing any cleaning, maintenance, or troubleshooting checks.

Reassemble all parts securely before operating vacuum.

DO NOT operate the vacuum without the pre- motor filters and dust cup in place.

DO NOT operate the vacuum with WET filters.

IMPORTANT: Make sure all filters are completely dry before inserting back into vacuum.

WARNING: Never insert sharp objects into any opening to clear an obstruction.

IMPORTANT: Damages caused while clearing or attempting to clear blockages are not covered under your product’s limited warranty.

Screen

Filter

Fig. 24

Fig. 22 Fig. 23

EMPTYING THE DUST CUP

The dust cup needs to be emptied each time you vacuum and periodically during cleaning, when the dust cup appears full.

1Undo the latches on the sides of the dust cup by lifting them up and outwards to remove the dust cup from the motor base. (Fig. 22)

2Hold the dust cup over a trash receptacle and press the bottom door release button. (Fig. 23) Tap gently to empty contents. Press the door shut again until it clicks.

3If needed, turn the dust cup upside down over the trash receptacle and press the top door release button. (Fig. 24) Tap gently to remove contents.

Use a dry cloth or paper towel to remove debris stuck to the screen filter inside the dust cup. Press the door shut again until it clicks.

4Replace the dust cup on top of the motor base. Hook the two latches onto the tabs on the sides of the dust cup and push down to lock.

13

NV350Q_26_IB_ENG_101019.indd 13 10-10-19 9:19 AM